Chery Tiggo 5 (T21). Manual — part 242
20–
5
20
ON-VEHICLE SERVICE
Drive Shaft Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the front wheel (
4. Drain the transmission oil (
).
5. Remove the fixing nut from front axle left drive shaft.
a. Using a nut chisel and a hammer, loosen the staked
part of nut.
b. While applying brake, remove the drive shaft fixing
nut.
(Tightening torque: 300 ± 20 N·m)
RT21220050
CAUTION
Loosen the staked part of nut completely, otherwise it will damage the thread of drive shaft.
RT21220060
20–
6
20
6. Remove the drive shaft.
a. Disengage the front left wheel speed sensor wire
harness and front left brake hose assembly (arrow)
from front left shock absorber assembly.
b. Remove the coupling bolt (arrow) between front left
wheel speed sensor and front left steering knuckle
assembly, and disengage the front left wheel speed
sensor carefully.
(Tightening torque: 10 ± 1 N·m)
c. Remove the coupling nuts and coupling bolts between
front left steering knuckle and shock absorber.
(Tightening torque: 180 ± 10 N·m)
d. Using a crowbar, pry out the drive shaft.
RT21230040
RT21220110
RT21220150
RT21200020
20–
7
20
e. Remove the set ring.
Installation
Installation is in the reverse order of removal.
RT21200030
CAUTION
DO NOT damage the constant velocity universal joint dust boot.
DO NOT use excessive force to pull the drive shaft to prevent the constant velocity universal joint from
dropping.
Use crowbar carefully to prevent damage to oil seal.
Adjust the wheel alignment if necessary.
20–
8
20
Inner Ball Cage
Disassembly
HINT:
Use the same disassembly and assembly procedures for left and right drive shaft assemblies.
1. Remove the drive shaft assembly (
2. Remove the inner ball cage dust boot clamp.
a. Using needle nose pliers, remove the inner ball cage
dust boot clamps.
3. Remove the inner ball cage.
a. Separate the dust boot from inner ball cage in the
direction of arrow.
CAUTION
DO NOT put matchmarks on the rotating surface of rotary drum.
Operate carefully to prevent the dust boot from being damaged.
RT21200040
RT21200051
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст