Chery Tiggo 5 (T21). Manual — part 157
12–
30
12
b. Loosen the elastic clamp (1) and disconnect the
connection between radiator discharge hose and
radiator assembly.
c. Loosen the elastic clamp (2) and disconnect the
connection between engine inlet pipe and radiator
assembly.
d. Remove the radiator.
Installation
Installation is in the reverse order of removal.
2
1
RT21120280
12–
31
12
Water Pump Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the engine trim cover assembly (
).
4. Drain the coolant (
).
5. Remove the accessory drive belt (
).
6. Use an engine equalizer to hang the engine.
7. Remove the engine right mounting assembly (
).
8. Remove the engine timing belt (
).
9. Remove the water pump assembly.
a. Remove the fixing bolt (arrow) from timing belt idler
pulley, and remove the timing belt idler pulley.
(Tightening torque: 40 + 5 N·m)
b. Remove 6 fixing bolts (arrow) from water pump
assembly.
(Tightening torque: 8 + 3 N·m)
WARNING
Always make sure engine is cold before operating cooling system.
Never open expansion tank cap or remove drain cock plug when engine is operating or cooling system
overheats. The engine coolant and steam with high-pressure and overheat may flow out and cause
serious personal injury.
If your body contacts coolant accidentally, clean it with water immediately. If it is serious, please go to
hospital.
CAUTION
Be sure to wear necessary safety equipment to prevent accidents when repairing.
Try to prevent body paint surface from being scratched during removal and installation.
RT21120290
RT21120300
12–
32
12
c. Remove the water pump assembly and gasket.
Inspection
1. Check water pump gasket.
Check water pump gasket for wear or bends. If wear or
bends are found, replace the gasket.
2. Check water pump assembly.
Check water pump assembly carefully. If any of the following occurs, replace the water pump assembly
immediately.
a. Contact surfaces of water pump assembly and cylinder block is uneven.
b. Impeller of water pump assembly is damaged.
c. Bearing of water pump assembly is loosened.
d. There is abnormal noise when water pump assembly is turning.
Installation
Installation is in the reverse order of removal.
RT21120310
CAUTION
Clean the installation surface of water pump assembly.
If water pump is damaged, replace rather than attempt to repair it.
Check that coolant has been added to the specified level after installation.
Perform cooling system pressure test after adding coolant. check for leakage in the cooling system.
1
13
SQR484F LUBRICATION SYSTEM
Description 13-3
Specifications 13-5
Tools 13-6
Lubrication System Flowchart
Removal 13-13
Installation 13-14
Removal 13-15
Installation 13-15
Removal 13-16
Inspection 13-16
Installation 13-17
Removal 13-18
Installation 13-19
Removal 13-20
Installation 13-22
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст