Chery Tiggo 5 (T21). Manual — part 232
18–
117
18
Primary Shaft Pressure Sensor
Removal
1. Turn off all the electrical devices and ignition switch.
2. Disconnect the negative battery cable.
3. Raise the vehicle with a lifter.
4. Drain the automatic transmission fluid (
).
5. Disconnect the wire harness connector of the primary
shaft pressure sensor.
6. Remove the primary shaft pressure sensor (1).
(Tightening torque: 15 - 22 N·m)
Installation
Installation is in the reverse order of removal.
RT21180400
1
RT21180410
CAUTION
Keep clean of sensor and contact surface between sensor and transmission, and avoid dust or impurity
entering the transmission.
During installation, apply automatic transmission fluid on the O ring of the sensor.
Add automatic transmission fluid (
18–
118
18
Secondary Shaft Pressure Sensor
Removal
1. Turn off all the electrical devices and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the air filter (
).
4. Disconnect the wire harness connector of the secondary
shaft pressure sensor (arrow).
5. Remove the secondary shaft pressure sensor (1).
(Tightening torque: 15 - 22 N·m)
Installation
Installation is in the reverse order of removal.
RT21180420
1
RT21180430
CAUTION
Keep clean of sensor and contact surface between sensor and transmission, and avoid dust or impurity
entering the transmission.
During installation, apply automatic transmission fluid on the O ring of the sensor.
18–
119
18
Transmission Range Sensor
Removal
1. Apply the parking brake.
2. Turn off all the electrical devices and ignition switch.
3. Disconnect the negative battery cable.
4. Remove the battery, battery tray and tray bracket (
).
5. Insert the mechanical key (3) in the emergency unlock
hole (2) and press the mechanical key to hold down the
emergency unlock switch, and move the shift lever (1) to
the N (neutral) position to release the shift lock.
6. Remove the gear shift cable (1) and arm (2) connecting
nut (3).
(Tightening torque: 16 - 20 N·m)
7. Disconnect the transmission range sensor wire harness
connector (arrow).
CAUTION
When removing and installing the transmission range sensor, make sure that the gear shift lever is at "N"
position.
R
S
3
1
2
RT21180440
RT21180450
1
3
2
RT21180460
18–
120
18
8. Remove the gear shift arm fixing nut (1).
(Tightening torque: 18 - 25 N·m)
9. Take out the gear shift arm spring gasket (2).
10.Take out the gear shift arm (3).
11.Remove the transmission range sensor fixing bolts
(arrow).
(Tightening torque: 10 - 12 N·m)
12.Take out the transmission range sensor (4).
Installation
Installation is in the reverse order of removal.
RT21180470
1
3
4
2
CAUTION
After the spring gasket of the gear shift arm is removed, use a new spring gasket during installation.
During installation, align the hole of gear shift arm to the hole of transmission range sensor and fix them
with a proper tool.
After installation, inspect the gear shift lever position. Adjust the gear shift cable as necessary.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст