Chery Tiggo 5 (T21). Manual — part 233
18–
121
18
Valve Body Case
Removal
1. Turn off all the electrical devices and ignition switch.
2. Disconnect the negative battery cable.
3. Raise the vehicle with a lifter.
4. Drain the transmission fluid (
5. Remove the valve body case fixing bolts and remove the
valve body case (1).
(Tightening torque: 10 - 12 N·m)
HINT:
When removing the valve body, do not damage the joint
surface of the transmission case.
Installation
Installation is in the reverse order of removal.
1
RT21180480
CAUTION
Before installation, clear the sealant residues on the joint surface of the transmission case and clean it
up.
Keep the installation parts clean and avoid foreign matter entering the transmission.
During installation, apply sealant on the joint surface of the valve body case and transmission evenly.
After adding fluid, inspect for fluid leakage.
18–
122
18
Valve Body
Removal
1. Turn off all the electrical devices and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the battery, battery tray and tray bracket (
).
4. Disconnect the wire harness connector of the
transmission solenoid as shown in the illustration.
5. Use a proper tool to remove the transmission solenoid
wire harness assembly clamp.
6. Remove the transmission range sensor (
7. Raise the vehicle with a lifter.
8. Drain the transmission fluid (
9. Remove the valve body case (
RT21180490
RT21180500
18–
123
18
10.Remove the positioning plate fixing bolt (1).
11.Remove the positioning plate (2).
12.Remove the valve body fixing bolts.
(Tightening torque: 8 - 10 N·m)
13.Remove the valve body (1), steel ball (3) and drive lever
(2).
14.Remove the transmission fluid temperature sensor (1)
from the valve body.
15.Remove the wire harness bracket fixing bolt (2).
16.Remove the solenoid press plate fixing bolts.
17.Take out the solenoid and wire harness assembly.
Installation
Installation is in the reverse order of removal.
2
1
×19
RT21180510
2
3
1
RT21180520
2
1
RT21180530
18–
124
18
CAUTION
Before installation, clear the sealant residues on the joint surface of the transmission case and clean it
up.
Keep the installation parts clean and avoid foreign matter entering the transmission.
During installation, apply automatic transmission fluid on the O ring of solenoid wire harness assembly.
During installation, apply sealant on the joint surface of valve body case and transmission evenly.
After adding fluid, inspect for fluid leakage.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст