Chery Tiggo 5 (T21). Manual — part 468
43–
52
43
b. Take out the front left door glass rear guide rail
assembly from the slot.
Installation
Installation is in the reverse order of removal.
RT21430130
CAUTION
After glass regulating system is installed, make sure that the window glass can go up and down smoothly
and freely without any vibration, chattering or shock loading, etc.
43–
53
43
Front Door Power Glass Regulator Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the front left door protector assembly (
4. Remove the front left door assist grip mounting bracket assembly (
).
5. Remove the front left door protective film assembly (
).
6. Remove the front left door glass assembly (
7. Remove the front left door power glass regulator assembly.
a. Disconnect the connector (1) from front left door
power glass regulator assembly.
b. Remove 6 fixing bolts (arrow) from front left door
power glass regulator assembly, and remove the front
left door power glass regulator assembly.
(Tightening torque: 9 ± 1 N·m)
CAUTION
Make sure to wear safety equipment to prevent accidents when removing front door power glass
regulator assembly.
Appropriate force should be applied when removing front door power glass regulator assembly. Be
careful not to operate roughly.
1
RT21430140
43–
54
43
Inspection
1. Check front door power glass regulator motor.
a. Apply battery voltage to the terminals of power glass
regulator motor connector, and check the operation of
power glass regulator motor according to the table
below.
If result is not as specified, replace front door power
glass regulator assembly.
Installation
Installation is in the reverse order of removal.
RT21430150
1 2
-
+
Measurement Condition
Specified
Condition
Battery positive
(+)
Battery negative
(-)
1
2
UP smoothly
2
1
Down smoothly
CAUTION
After front door power glass regulator is installed, make sure that the window glass can go up and down
smoothly and freely without any vibration, chattering or shock loading, etc.
43–
55
43
Power Glass Regulating Switch
Removal
HINT:
Use the same procedures for the front right/rear right side and rear left side.
Procedures listed below are for the rear left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the left power glass regulating switch assembly.
a. Remove the cushion rubber (1) from power glass
regulating switch assembly.
b. Remove the fixing screw (2) from power glass
regulating switch assembly.
(Tightening torque: 2 ± 0.5 N·m)
c. Using a screwdriver wrapped with protective tape, pry
up the power glass regulating switch assembly.
CAUTION
Make sure to wear safety equipment to prevent accidents when removing power glass regulating switch.
Appropriate force should be applied when removing power glass regulating switch. Be careful not to
operate roughly.
Try to prevent rear door protector assembly from being scratched when removing power glass regulating
switch.
RT21430200
2
1
RT21430210
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст