Chery Tiggo. Manual — part 318
TRANSFER CASE (4X4)
GENERAL INFORMATION
08-327
Description
08-327
Operation
08-327
ON-VEHICLE SERVICE
08-328
Transfer Case
08-328
Removal & Installation
08-328
TRANSFER CASE UNIT REPAIR
08-329
Transfer Case
08-329
Disassembly
08-329
Assembly
08-331
GENERAL INFORMATION
Description
Transfer case is attached to the transaxle housing.
Operation
The transfer case transfers the torque output from the transaxle to the ITM controller.
1 - Transaxle Housing
2 - Rear Transaxle Cover
3 - Axle Shaft Guide
4 - Front Different Housing
LTSM160007
08
ON-VEHICLE SERVICE
Transfer Case
Removal & Installation
1. Drain the gear fluid from the transfer case.
• Fluid-filling plug (1)
• Fluid-limiting plug (2)
• Fluid-drain plug (3)
2. Remove the front intermediate drive shaft assembly.
3. Remove the sub-frame assembly.
4. Remove the left and right front axle shaft mounting
bolts (1).
5. Remove the transaxle and transfer case assembly (See Transaxle Assembly Removal & Installation in Section
08 Transaxle).
6. Remove the transfer case from the transaxle (8 bolts).
(Tighten: Transaxle and transfer case bolts to 80 N·m)
7. Installation is in the reverse order of removal.
LTSM160011
LTSM160012
TRANSFER CASE UNIT REPAIR
Transfer Case
Disassembly
1. Remove the front housing. Loosen 9 bolts (1) of
the housing, then remove the housing.
(Tighten: Transfer case front housing bolts to
35 N·m)
2. Remove
the
small
rear
housing
components.
Loosen the 4 bolts (1) and remove the rear hous-
ing components.
(Tighten: Rear intermediate shaft and rear differen-
tial bolts to 65 ± 6 N·m)
LTSM160013
LTSM160014
08
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст