Chery Tiggo. Manual — part 333
Specifications
Torque Specifications
DESCRIPTION
TORQUE (N·m)
Rear Stabilizer Bar Link
40 - 50
Lower Suspension Lever
40 - 50
Rear Shock Absorber to Rear Shock Absorber Mounting
Bracket
40 - 50
Control Arm Knuckle Pin to Control Arm
140 - 160
Rear Axle Front Suspension to Rear Sub-Frame
115 - 125
Rear Axle Front Suspension to Rear Driving Axle
75 - 85
Control Arm And Sub-Frame
170 - 190
Rear Rubber Buffer Assembly to Vehicle Body
22 - 28
Rear Axle Rear Suspension Cushion Assembly to Rear
Axle
75 - 85
Upper Link to Rear Sub-Frame
100 - 120
Lower Control Arm to Rear Sub-Frame
100 - 120
Lower Control Arm to Trailing Arm
100 - 120
Upper Link to Trailing Arm
100 - 120
Rear Suspension to Bracket
115 - 125
Rear Suspension, Longitudinal Beam Of Engine And
Sub-Frame
75 - 85
Rear Stabilizer Bar Clamp to Vehicle Body
22 - 28
Rear Trailing Arm to Vehicle Body
140 - 160
Soft Gasket And Bracket Of Rear Suspension
110 - 130
Sub-Frame And Gasket Of Vehicle (Rear) Body
170 - 190
Sub-Frame And Longitudinal Beam Assembly
75 - 85
Upper End Of Rear Shock Absorber to Vehicle Body
22 - 28
Wheel Mounting Nut 110
GENERAL INFORMATION
DIAGNOSIS & TESTING
Vehicle Inspection
Inspect the rear axle for the following:
• Check the rear axle for loose bearings.
• Check the rear axle hub for any damage or excessive runout.
Vibration At High Speed
This problem could be a result of the following:
• Foreign material (mud, etc.) packed on the backside of the wheel(s).
• Out of balance tires or wheels.
• Improper tire or wheel runout.
10
ON-VEHICLE SERVICE
Rear Lower Control Arm
Removal & Installation
1. Raise and support the vehicle.
2. Remove the bolt that joins rear stabilizer bar and rear suspension lower control arm (See Rear Stabilizer Bar
Link Removal & Installation in Section 10 Suspension).
3. Remove the retaining bolt (1) connecting the lower
control arm and rear trailing arm.
(Tighten: Lower control arm to rear trailing arm bolt
to 80 - 100 N·m)
4. Remove the retaining bolt (1) connecting the upper
control arm and rear sub-frame assembly.
(Tighten: Upper control arm and rear sub-frame
assembly bolt to 80 - 100 N·m)
5. Installation is in the reverse order of removal.
Installation Notes:
• After installation, each bolt must be tightened to the
required tightening torque.
LTSM100061
LTSM100066
Rear Upper Control Arm
Removal & Installation
1. Raise and support the vehicle.
2. Remove the retaining bolt (1) connecting the upper
control arm and rear trailing arm.
(Tighten: Upper control arm to rear trailing arm bolt
to 80 - 100 N·m)
3. Remove the retaining bolt (1) connecting the upper
control arm and rear sub-frame assembly.
(Tighten: Upper control arm to rear sub-frame
assembly bolt to 80 - 100 N·m)
4. Installation is in the reverse order of removal.
Installation Notes:
• After installation, each bolt must be tightened to the
required tightening torque.
ON-VEHICLE SERVICE
LTSM100068
LTSM100065
10
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст