Chery Tiggo. Manual — part 54
10. Disconnect and remove the fuel line (2) at the fuel
rail.
11. Remove the fuel pressure regulator retaining bolt
(1) and set the fuel pressure regulator aside.
(Tighten: Fuel pressure regulator bolt to 9 N·m)
12. Remove the air inlet hose and the air cleaner case
assembly.
13. Remove the accelerator cable bolt from the cylinder head.
14. Disconnect and remove the following electrical connectors:
Coolant temperature sensor
Crankshaft position sensor
Camshaft position sensor
Ignition coil
Four fuel injectors
Air flow sensor
Canister solenoid valve
EGR control solenoid valve
Throttle position sensor
A/C compressor
Oil pressure sensor
Power steering pump pressure switch
Generator
Upstream oxygen sensor
Knock sensor
Idle air control motor
ON-VEHICLE SERVICE
LTSM040006
LTSM020160
15. Remove the pipe from the canister control valve.
16. Disconnect the heater hoses (1) on the vehicle.
17. Remove the vacuum line from the brake booster.
18. Remove the dipstick.
19. Remove the accessory drive belt (See Accessory Drive Belt Removal & Installation in Section 02 Engine).
20. Remove the A/C compressor high and low pres-
sure pipe bolts (1) & (2).
ON-VEHICLE SERVICE
LTSM130010
LTSM130008
02
21. Disconnect the following automatic transaxle elec-
trical connectors:
• Output shaft sensor (1)
• Input shaft sensor (2)
• Electromagnetic valve switch connector (3)
• Gear switch connector (5)
22. Disconnect the transaxle fluid lines (6) using a suit-
able tool.
23. Remove the shift cable (4) from the transaxle
assembly.
24. Remove the catalytic converter to exhaust manifold
bolts (1).
(Tighten: Exhaust manifold bolt to 49 ± 5 N·m)
25. Remove the front axle shaft (See Front Axle Shaft Removal & Installation in Section 09 Driveline & Axle).
26. Raise and support the vehicle.
27. Drain the engine oil.
28. Remove the power steering pump fluid line and set aside (See Power steering pump Removal & Installation in
Section 11 Steering).
29. Lower the vehicle and install engine lift chain hangers.
ON-VEHICLE SERVICE
LTSM080153
LTSM020189
30. Remove the bolts (1) securing the front engine
mount.
(Tighten: Engine front mount bolt to 60 N·m)
31. Remove the bolts (2) securing the rear engine
mount and the bolts (1) securing the mount
bracket.
(Tighten: Engine rear mount bolt to 60 N·m)
32. Remove the bolts (2) securing the left transaxle
mount and the bolts (1) securing the mount
bracket.
(Tighten: Left transaxle mount bolt to 70 N·m)
ON-VEHICLE SERVICE
BESM080035
LTSM020188
LTSM020156
02
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст