Chery Tiggo. Manual — part 55
33. Remove the bolts (2) securing the right engine
mount and the bolts (1) securing the mount
bracket.
(Tighten: Engine right mount bolt to 70 N·m)
34. Remove the mount assembly.
35. Verify all components between the engine and vehicle are disconnected.
36. Hoist the engine from vehicle.
CAUTION:
Verify all electrical connectors are disconnected prior to engine/transaxle removal.
37. Separate engine and transaxle.
(Tighten: M12×1.75 bolts to 70 ± 5 N·m)
(Tighten: M10×1.5 bolts to 50 ± 5 N·m)
38. Installation is in the reverse order of removal.
ON-VEHICLE SERVICE
LTSM020155
Engine Timing Belt
Removal & Installation
ON-VEHICLE SERVICE
LTSM020048
02
NOTE :
The following special tools are required to perform the repair procedure:
• MB-990767 - Timing Belt Spanner Wrench
• MD-998785 - Timing Belt Gear Holder
• MD-998767 - Automatic Tensioner Socket
1. Drain the cooling system (See Cooling System Draining and Filling in Section 06 Cooling).
WARNING!
Always allow the engine to cool before opening the cooling system. Do not loosen the coolant pressure relief
cap when the engine is operating or the cooling system is hot. The cooling system is under pressure; steam and
hot liquid can come out forcefully when the cap is loosened slightly. Failure to follow these instructions may
result in serious personal injury.
2. Attach an engine hoist to the engine.
3. Raise the engine with the engine hoist, just enough to support the engine.
1 - Right Engine Mounting Bracket
2 - Spacer
3 - Upper Balance Shaft Pulley
4 - Upper Balance Shaft Timing Belt
5 - Upper Balance Shaft Timing Belt Tensioner
6 - Crankshaft Sensing Blade
7 - Upper Timing Belt Cover
8 - Lower Timing Belt Cover
9 - Timing Belt Automatic Tensioner
10 - Idler Pulley
11 - Crankshaft Bolt
12 - Crankshaft Timing Belt Pulley
13 - Lower Balance Shaft Pulley
14 - Crankshaft Position Sensor
15 - Power Steering Bracket
16 - Timing Belt Rear Cover
17 - Timing Belt
18 - Camshaft Timing Pulley
19 - Camshaft Pulley Bolt
20 - Crankshaft Upper Balance Shaft Pulley
21 - Tensioner Arm
22 - Tensioner Pulley
ON-VEHICLE SERVICE
LTSM020048
4. Remove the engine right mount bolts (2) and the
engine right mount bracket bolts (1).
(Tighten: Engine right mount bolts to 70 N·m)
5. Remove the accessory drive belts (See Accessory
Drive Belt Removal & Installation in Section 02
Engine).
6. Remove the crankshaft vibration damper bolts (1).
(Tighten: Crankshaft vibration damper bolts to
25 N·m)
7. Remove the timing belt upper cover.
(Tighten: Timing belt upper cover bolts to 11 N·m)
8. Remove the timing belt lower cover.
(Tighten: Timing belt lower cover bolts to 11 N·m)
9. Loosen the timing belt tensioning pulley bolt.
10. Remove the timing belt.
NOTE: Remember the rotation direction of the timing belt in order to avoid any error when reassembling.
ON-VEHICLE SERVICE
LTSM020155
LTSM020153
02
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст