Chery S11 / Chery QQ. Manual — part 85
Chery QQ Service Manual
Remove the Luggage Compartment
1. Loosen 5 bolts on the left lining board
and take them out.
2. Disconnect the trunk cable set
and loosen wiper pipe.
3. Hold the trunk and unfasten 4
fixed bolts on the hinge.
Chery QQ Service Manual
4. Remove hydraulic rod and take
out luggage compartment assembly.
Remove the lock assembly(mechanical)
1.Detach the connectors.
2.Unfasten 2 fixed bolts and take out the
lock.
Remove the lock assembly(electric)
1. Detach the connectors.
Chery QQ Service Manual
2. Unfasten 3 fixed bolts to take out the
lock, and disconnect the motor wire.
Remove the electric switch
(1) Unfasten fixed bolts of the trunk.
(2) Detach the connecting rod
on the lock switch of trunk.
Chery QQ Service Manual
(3) Unfasten 2 fixed bolts on the trunk
lock.
(4) Take out the lock assembly.
Adjust the trunk door
1. Adjust the trunk door
(1)Loosen bolts, and adjust the door in forward/backward, and left/right directions.
(2)Increase or decrease the amount of washers between hinge and trunk door to adjust
the front end in upward or downward directions.
Torque: 11.5 Newton-meter (115 kg-cm, 8.3 pound-foot)
2.Adjust the lock crossbar
Gently knock the crossbar with hammer or bronze bar for adjustment.
Torque: 5.4 N.m (55 kg-cm, 48 pound-inch)
Replace the trunk door support
1. Remove the trunk door support
(1)Unfasten the support bolts out of trunk door hinge.
(2)Turn the back end of the support downward, and take the support out of bracket.
2. Replace the trunk door support
Note: Be careful of when operating the support.
(1)There is compressed air in the support cylinder. Do not disassemble the support.
(2)If the support is to be replaced, drill a small hole with diameter of 2.0-3.0 m
(0.079-0.118 inch)on the shadow area of cylinder to fully release compressure, then
abandon it.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст