Chery S11 / Chery QQ. Manual — part 215
SQR7080 Maintenance Manual 372 Engine Mechanical System
Water pump pulley assembly
wrench
water pump Assembly
Measuring
tools
Feeler, gap gauge, caliper, ruler, cylinder gauge, gap ruler, pressure meter, torque
wrench
Tool
Piston ring dismounting device
Oils
Engine lubiricating oil, adhesion agents
Chapter 2 Timing Blet Service
1. Configuration diagram
1 Water pump pulley
2 Timing belt cover
3 Timing belt
4 Torsion shock absorber
5 Timing pulley damper
6 Tensioner
7 Crankshaft timing pulley
※ :
Non-reusable part
Unit:N·m(kg·cm)
3
SQR7080 Maintenance Manual 372 Engine Mechanical System
Remove torsional vibriation damper.
Remove water pump pulley.
Remove the water pump pulley according to the
illustration.
Remove with SST,if there are any.
Please remove with screwdriver and wrench
accordingly,if there is no SST at hand.
SST
Remove torsional vibriation damper
(1) Prevent the gear ring from rotating with SST.
(2) Remove bolt of torsional vibriation damper.
图
29
4
SQR7080 Maintenance Manual 372 Engine Mechanical System
Remove timing cover cap
Torque: 6±1N.m
Remove timing pulley damper
Remove the tensioner
(1)
Carry out the operation at the upper thrust point
of compression of the first cylinder piston
(2) After removing the timing cover cap,turn the bolt
and rotate the timing gear clockwise with wrench,align
timing mark of camshaft timing gear with the cam
mark of camshaft cover cap;
Attention: You can rotate the engine clockwise
only,after installing the pulley;
Before removal,make a arrow mark on the position of
timing mark,assemble according to original state.
(3) Make sure that the crankshaft timing pulley wheel
mark is aligned with the mark of the oil pump.
(4) Remove the tensioner bolt, and take off the
tensioner
Do“mark”
Timing mark
Clockwise
Timing mark
5
SQR7080 Maintenance Manual 372 Engine Mechanical System
Remove the timing belt.
[Caution] It is absolutely not allowed to use screw
driver or some other sharp-edged tools to remove the
belt.
Attention: Pay Attention to the following points while
using timing belt:
- Don’t bend the belt even at a small angle,otherwise
it will result in rope fracture inside the belt.
- - Service life of belt is short,don’t pollute the belt
with grease and water.
- You have no choice but rotate the engine
clockwise after installing the belt.
2.7 Remove the crankshaft timing gear
6
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст