Chery S11 / Chery QQ. Manual — part 33
Chery QQ Service Manual Chassis System
Recoding
Yes
Abnormal
Replace harness
6、Supply terminal 30
Possible cause
6、DTC 00668
Means too high source voltage
·ABS fuse burn out
·Too low or too high battery
voltage
·ABS harness damage
·ABS ECU damage
Normal
Check ABS fuse 30 Replace fuse
Normal
Abnormal Abnormal
Check ABS harness Fix connecter
Normal
Try again. No Normal?
Yes
Normal
Check battery
Normal
Replace ABS ECU
Check if coding correct
Check if ABS harness god
NO
Disconnect between ABS
harness and ECU, turn on
switch
and
measure
voltage:
Terminal8,9: 9.5-16.5V
Terminal 24,25: 9.5-16.5V
MK20I/E:
Terminal8,4: 9.5-16.5V
7、ABS service preternatural
Possible cause
7、DTC 01130
Means interfere of high frequency or bad
signal
·Interfere of high frequency
·Bad sensor or harness
·ABS ECU damage
45
Chery QQ Service Manual Chassis System
Abnormal
Replace sensor
of sensor
Check Out put voltager
Normal Normal
Check senso
Replace ABS ECU
Check harness
8、Non- DTC troubleshooting table
(1)Key on, engine of, ABS warning light off
Possible cause
Means ABS light off, open light circuit, lamp
burn out or light control unit damage
·Fuse burn out
·ABS lamp burn out
·Open source circuit
·ABS light control
unit damage
Check ABS light fuse Abnormal
Replace
Normal
Check fuse block Fix
Normal
Disconnect ABS ECU Conn Yes
Abnormal
Turn on switch:ON Check lamp Replace
Light is up?
No
Abnormal
Yes Check ground Abnormal
Chech ABS light or Replace harness
harness ground
Short or ground Normal
Abnormal
Yes Check connector Abnormal Fix connector
Replace harness of ABS light
Normal No Refer to service
Fault again? points
Yes
Replace controller
46
Chery QQ Service Manual Chassis System
(2)Engine start, light is on
Possible cause
Means ABS light controller damage or open
·Light controller damage
·ABS light controller open
·ABS ECU fault
Attention: This malfunction only appears on normal source voltage and without
DTC.
Yes
器之间的电线是否开路 Replace harness
NO Abnormal
Check if open between
ECU and light
Check controller Replace
Normal
Replace ABS ECU
(3)ABS abnormal
Possible cause
Means the fault is connect with the driver
or road
·Sensor bad installation
·Bad harness
·Sensor damage
·Tooth ring damage
·Dirt on sensor
·Bearing damage
·ABS HCU damage
·ABS ECU damage
47
Chery QQ Service Manual Chassis System
No
Install correctly
Yes
Install sensor right?
Abnormal Abnormal
Replace
Normal
Abnormal
Replace
Abnormal
Abnormal
Replace ABS HCU
Fix or replace
Fix socket
Normal
No
Normal
Check out voltage
Check HECU with tester
Check sensors
Check each tooth ring
Check bearing
Check plug of ABS ECU
and connector
Fault again?
Normal
Normal
Normal
Normal
Normal
Normal
Abnormal
Refer to ser-
vice points
Abnormal
Replace ABS ECU
Fix harness or
connecter
Measure resistance of ABS
harness
Specifications:1.0-1.3kΩ
Shake harness and connector
MK20I/E
Front left:1-2
Front right:19-20
Rear left:5-6
Rear right:22-23
48
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст