Chery S11 / Chery QQ. Manual — part 273
Chery QQ Maintenance Manual Transmission System
(2)Remove the snap ring.
(3)Use oil pressure to extrude output shaft.
1
、
Oil
pressurer
2
、
Output
(4)Remove the left oil seal.
(5)Take out the bearing race snap ring .
Snap ring
(6)Remove the central bearing.
Check:
● Check if the boot has been broken or aged.
● Check if the snap ring, snap ring and boot hoop have cracks or distortion.
III、Installation
1、Installation of driven shaft.
(1) Clean the parts (except the boot) and dry the parts with compressed air.
(2). Use a piece of clean and dry cloth to clean the boot, be sure not to use skim
milk (such as gasoline or coal oil).
(3)Put the boot onto the axle till the small diameter set in the shaft slot and fix
the hoop.
-104-
Chery QQ Maintenance Manual Transmission System
1、 Boot
2、Boot hoop
(4)Install the holding .
Caution: When installing the holding,keep the small diameter towards the shaft
end.
1、 Holding
(5)Use special tool (A) to install the snap ring.
1.Snap ring
-105-
Chery QQ Maintenance Manual Transmission System
(6)Spread 30-40 g of SUZUKI H on the surface of the holding.
(7). Put the holding into the bell-mouthed ,and then put the snap ring in the snap
ring slot.
Caution: snap ring hatch(A) can not aim at the ball.
(8)Fill in 23-35g of SUZUKI H, put the boot on the bell-mouth, Then install
boot on bell-mouth。
After installing the boot, insert a drivenscrew into bell-mouthed
boot, send air into boot.
-106-
Chery QQ Maintenance Manual Transmission System
9. Fix the boot on the bell-mouthed. Adjust the measure(A) and (B) to accord
with the fig. Bellow.
Left driven shaft
Right driven shaft
Differential
side
lubricate
lubricate
lubricate
Wheel side
(2)install output shaft and bearing race.
Install the output shaft according to the reverse order and pay attention to the
followings.
When installing the bearing race snap ring, be sure the snap ring has been
fixed tightly in the central bearing race snap ring slot; keep the left oil seal in the right
direction shown in the fig. below.
1、 Snap ring
2 、 Central
bearing race
1、Left oil
seal
2、Hubricate
Fix the snap ring tightly in the snap ring slot.
When install the right oil seal, keep the right direction shown in the fig. below.
-107-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст