Chery S11 / Chery QQ. Manual — part 272
Chery QQ Maintenance Manual Transmission System
(1)Let out the transaxles oil.
(2)Remove the driven shaft cardan joint to make the snap ring. Break away from
the differential cardan joint Splined hub.
1、Driven shaft cardan joint
(left)
(3) Remove the joint from the Suspension arm.
(4)Remove the ball joint bolt and nut and disconnect the suspension arm from the
steering .
1、 Steering
2 、 Ball joint bolt and nut
3、
Suspension
arm
(5) For disassembling the driven shaft assembly, first pull out the inner cardan
joint,second pull out the wheel cardan joint from the steering .
1、Driven shaft nut A、Rivet
-100-
Chery QQ Maintenance Manual Transmission System
Caution: When disassembling the driven shaft assembly,
Be sure to prevent the rough touch and collision.
2. Disassembling the right shaft.
On the ground:
Loosen the rivet and remove the driven shaft nut and gasket .
On the Lift:
(1)Use plastic hammer to knock the driven shaft cardan joint to break the snap ring
away from differential cardan joint splined hub.
(2)Disconnect the joint from the suspension arm.
(3)Remove the ball joint bolt and nut, and then disconnect the suspension arm
from the steering.
(4)For disassembling the driven shaft assembly, first pull out the inner cardan joint
from the output shaft, secondly pull out the end of wheel cardan joint from the
cardan joint.
1 、 Steering 2 、 Ball joint
bolt and nut
Caution: When disassembling the driven shaft assembly, Be sure to prevent the
rough touch and collision.
(5)Let out the transaxles oil.
-101-
Chery QQ Maintenance Manual Transmission System
(6) Loosen the central bearing seat bolt, remove the output shaft from
differential side gear.
1 、 centralbearing 2 、
1、 Central bearing
2、 Central bearing race
3. Disassemble the driven shaft.
(1) Remove the differential cardan joint boot hoop.
1、 Boot hoop
(2) Move the boot to the middle position and take out the shaft from the
bell-mouthed.
1、Boot 2、 Snap ring
-102-
Chery QQ Maintenance Manual Transmission System
(3)Scrape off the lubricant and remove the holding snap ring with special tool (A).
1、 Boot hoop
(4)Draw out the holding and boot.
1、 Holding
Notice:
The end of wheel cardan joint。
4. Disassemble the output shaft and bearing race.
(1) Remove the right oil seal from the central bearing race.
1 、
Central
bearing race
-103-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст