Chery Fora (Elara A520). Manual — part 129
8
9
7.
Crankshaft phase alignment
Screw off the bulkhead of cylinder block,
screw the crankshaft tool into it, rotate the
crankshaft
until
the
crankshaft
tool
completely clamps the crankshaft. At this
time, the crankshaft cannot rotate clockwise
and counterclockwise.
8.
Mount and strain the timing belt
Mount the timing belt in the position shown
in the figure, use allen wrench to rotate the
tension pulley in order to strain the belt,
fasten the tension pulley bolt. And fasten the
fixed bolt of air intake and exhaust camshaft
pulleys and the camshafts.
Torque:120±5Nm.
9.
Lift down the special timing calibration
tools, and then fasten the valve chamber
cover, timing belt cover, the right engine
mounting bracket of engine, and
dynamo belt.
Crankshaft Tool
10
SECTION II LIFTING AND INSTALLATION OF ENGINE
1. When the ignition switch is shut off, you
can pull out the battery earth cable,
loosen the fastening screw,and dismantle
the battery.
2. Loosen the condenser drainpipe, screw
off the expanded pot lid, and discharge all
the anti-freezing solution.
3. Dismantle the airflow lines between the
throttle valve case and the air flow meter,
dismantle the (a) lead connector of air
flow meter, (b) lead connector of ignition
coil,(c) lead connector of canister
solenoid valve.
4. Remove the (d) the wire harness plug of
water temperature sensor, and (e) wire
harness plug of air intake and exhaust
camshaft position sensor.
b
a
c
e
d
11
5. Remove the (f) the harness plug of CBR
solenoid valve.
6. Dismantle (g) the earth cable bolt of
cylinder head, remove (h) the wire
harness plug of starter coil, (i) wire
harness plugs of four oil injectors, (j)
knock sensor plug, (k) wire harness plug
of throttle valve controller.
7. Remove (l.) CBR solenoid valve plugs,
and (m) oil temperature sensor plugs
8. Loosen (n) generator positive pole output,
pull out (o) exciting current harness plugs
as well as the plugs of relevant parts of
the A/C compressor, steering booster
pump, oxygen sensor, and A/C high-low
voltage switch.. Loosen the fixed bolt of
starter harness to confirm the plugs of all
parts are completely separated.
f
i
k
j
h
g
m
l
n
o
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст