Chery Fora (Elara A520). Manual — part 130
12
9. Dismantle (p) transmission gearshift
cable and (q) hydraulic pipe of clutch.
10. Use crane to hoist the engine hanger
from the top, and dismantle the two
hexagonal
flange
bolts
of
front
suspension bracket.
11. Dismantle the hexagonal flange bolts of
girder under the car body.
12. Remove the hexagonal flange bolts of
rear suspension-cushion assembly of
engine.
p
q
13
13.
Dismantle the coolant reservoir and
cleaning the reservoir.
14.
Loosen the three hexagonal flange bolts
of engine's right bracket.
15.
Loosen the three bolts of right
suspension cushion, and dismantle the
right suspension cushion assembly and
bracket.
16.
Dismantle the hexagonal flange bolts of
left suspension cushion in order to
ensure no connection between the
engine and car body. Lift down the
crane carefully and shift out the power
assembly.
14
SECTION III ENGINE ACCESSORIES
1 Replacement of Dynamo belt
1.1 Needed tools and auxiliary materials 13
#open end wrench and new dynamo belt
1.2 Process of removal
As the figure illustrated, rotate the13#open
end wrench counterclockwise and recede the
tension pulley. At the same time, the belt
tension shall disappear, so you can dismantle
the belt.
1.3 Installation steps
The installing steps are reverse to those for
removal.
2 Replacement of Generator Assembly
2.1 Needed tools and auxiliary materials
Allen wrench, ratchet wheel, 13# sleeve,
10# open end wrench.
2.2 Process of removal:
1)
Dismantle the negative pole harness of
battery.
2)
Dismantle the bolts connecting the
generator and harness, and take out the
harness.
3)
Pull out the harness plugs of generator
regulator.
15
4)
Dismantle dynamo belt (Process of
removal is shown in the “replacement of
dynamo belt”).
5)
Use 13# sleeve to dismantle the bolt (I)
connecting the generator and bracket.
2.3
Installation steps:
The Installation steps is opposite to Process
of removal.
6)
Use allen wrench to dismantle the bolt
(II) connecting the generator and
bracket, and then take out the generator.
3
Replacement
of
Air
Conditioner
Compressor
3.1
Needed tools and auxiliary materials
Small ratchet wheel, ratchet rod, 10# sleeve,
big ratchet wheel, 13# sleeve, crosshead
screwdriver, allen wrench coolant R134a,
gauze, A/C pressure gauge
3.2
Process of removal:
1)
Release Refrigerant for A/C compressor.
Screw off the nuts in the test pressure
port of high-pressure pipe, and use
screwdriver to press down the central
metal core in order to have the air
conditioner
pressure
released
completely.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст