Chery Fora (Elara A520). Manual — part 8
Chery Service Manual for A520 Body Dimension and Accessories
7
17.
Pry out the vanity mirror to replace the
bulb in the right sun visor with a flat
head screwdriver;
Figure 111
18.
Pry out the lamp house, remove the
screws, pull out the harness, and then
detach the indoor front ceiling light;
Figure 112
19.
Pry out the indoor rear ceiling light;
Figure 113
Chery Service Manual for A520 Body Dimension and Accessories
8
20.
Pry out the lamp house to replace the
bulb;
Figure 114
21.
Pry out the snap clip to detach the roof;
Assembly requirements: The front end height
of the roof should not interfere with the
installation of the front windscreen. The front
end roof corner should not be seen outside
the car with a visual angle along the level
direction the same height with the roof. The
roof edge should be in good fitting with the
weather strip of the door opening and the
luggage compartment and exposure of the
roof corner and non-tight edge holding down
are not allowed. The roof corners are not
allowed to raise outside and depress so as to
prevent the weather strip layer from non-flat
fitting. The roof edges should be in good
fitting with the arcs of the upper trim panel of
A, B, and C pillars with a fit clearance less
than 0.2 mm.
Figure 115
22.
Remove the fastening bolts (9 bolts) to
detach the sun roof assembly.
Figure 116
Chery Service Manual for A520 Body Dimension and Accessories
1
CHAPTER NINE BODY DIMENSION
Dimension of the beam:
Unit: mm
Chery Service Manual for A520 Body Dimension and Accessories
2
Assembly dimension of the body
Side view
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст