Chery Fora (Elara A520). Manual — part 7

Chery Service Manual for A520 Body Dimension and Accessories

3

bolts of the front row seats seat belts and
make sure that the latch of the seat belts
could be operated easily and the tightening
torque for the fixing nuts is 50±5 N•m.
(uniform thread fastening glue should be
applied to all fasteners of this assembly
before installing) The belts could extend and
shrink easily and could not slack after the
latch is fastened with the lock striker. The
installation angle of the left/right rear seat
belt retractor assembly is 90°. The tightening
torque for all fasteners of this assembly is
50±5N•m and the fasteners should be applied
with the thread fastening glue before
installing. The belts could extend and shrink
easily and could not slack after the latch is
fastened with the lock striker. The catch bolts
of the middle seat belt should be applied with
thread fastening glue and the tightening
torque of which is 50±5N•m. The lock screw
of the double end clip ring should be applied
with thread fastening glue and the tightening
torque of which is 50±10N•m;

Figure 99

Figure 100

7.

Remove the upper trim panel for B
pillar;

Figure 101

Chery Service Manual for A520 Body Dimension and Accessories

4

8.

Remove the two bolts and slider track;

Figure 102

9.

Remove the weather strip;

Figure 103

10.

The inner harness connector on the left
rear door as shown;

Figure 104

Chery Service Manual for A520 Body Dimension and Accessories

5

11.

From here outwards to pull out the
harness;

Figure 105

12.

Remove C pillar trim panel;

Figure 106

13.

Remove the weather strip from the left
rear door;

Figure 107

Chery Service Manual for A520 Body Dimension and Accessories

6

14.

Disassembling

the

passenger

grab

handle: lift the trim cover and unscrew
the two set screws to detach the handle:

Figure 108

15.

Disassembling the sun visor: unscrew
the fastening bolts;

Assembly requirement: The tightening force
for the screw should be proper and make sure
that the sun visor could work normally
without any looseness. The sun visor could
move freely when working normally without
any noise and being stuck.

Figure 109

16.

Remove the fixing base;

Assembly requirement: The fixing base could
seize the sun visor properly so as to prevent
the sun visor from breaking away when being
used.

Figure 110