Chery Fora (Elara A520). Manual — part 5
Chery Service Manual for A520 Body Dimension and Accessories
5
4. REPLACING THE SUN VISOR
4.1
Disassembling the sun visor
1)
Remove
the
roof.
(See
the
disassembling
methods
in
Body
Accessories for detailed disassembling
procedures.)
2)
Remove the locating clip as shown in
the figure. (Each at left and right)
3)
Draw out the sun visor backwards.
4.2
Installation
The installing steps are reverse to those for
removal.
5.
REPLACING
THE
SUN
ROOF
MOTOR
5.1
Disassembling the sun roof motor
1)
Turn on the power to run the sun roof to
the
full
close
position
before
disassembling. (i.e. the initial position of
the sun roof)
2)
Remove the roof interior trim/ceiling
light. (See Service Manual for the Body
Accessories for detailed disassembling
methods.)
Chery Service Manual for A520 Body Dimension and Accessories
6
3)
Disconnect the power supply control
line and the connecting wire between
the motor and the sun roof control unit
(SCU), and then cut off the band fixing
the motor harness.
4)
Remove the fixing bolts of the sun roof
motor to detach the sun roof motor.
5.2 Installing the sun roof motor
The installing steps are reverse to those for
removal.
6. REPLACING
THE
SUN
ROOF
CONTROL MODULE
6.1 Disassembling the sun roof control
module
1)
Turn on the power to run the sun roof to
the
full
close
position
before
disassembling. (i.e. the initial position of
the sun roof)
2)
Remove the roof interior trim/ceiling
light. (See Service Manual for the Body
Accessories for detailed disassembling
methods.)
3)
Disconnect the power supply control
line and the connecting wire between
the motor and the sun roof control unit
Chery Service Manual for A520 Body Dimension and Accessories
7
(SCU).
4)
Remove the connecting screws that
attach the module to the roof to detach
the sun roof module.
6.2 Installing the sun roof control module
The installing steps are reverse to those for
removal.
7. DETECTING AND MAINTENANCE METHODS FOR FAILURES
Distribution pipe blocks or folds
Check the distribution pipe
Water
leakage
The distance between the sun roof glass and
the roof hole is too big or the height of the
glass is incorrect
Adjust the relative position of the
glass
Wind noise
The distance between the sun roof glass and
the roof hole is too big or the height of the
glass is incorrect or the spoiler fails to work
Adjust the relative incorrect position
of the glass
Connecting, fuse and ground wire incorrect
Check the connection, fuse and
ground wire
SCU, sun roof motor incorrect
Check and replace the SCU and sun
roof motor
Sun visor runs off the slide rail or trim strip
breaks
Re-adjust the sun visor and install or
replace the trim strip
Abnormal
starting
and
running
Foreign material on the slide rail
Inspect and clear the foreign material
The sun visor runs off the slide rail or the
broken trim strip rubs the slide rail
Adjust and install the sun visor again
and re-install the trim strip (also
replace the broken parts)
Anti stick (A.T.S.) function fails to work
normally
Check for collision between the body
and the spoiler, relax the stressed
spring, inspect and clear the foreign
material on the slide rail
Starting in
error
The sun roof motor incorrect
Replace the motor
The sun visor runs off the slide rail or the
broken trim strip hinders the running
Adjust and install the sun visor again
and re-install the trim strip (also
replace the broken parts)
Distribution pipe collides with the body
Adhere the sponge buffer to around
the distribution pipe
Collision between the roof cover and the sun
roof frame
Apply glass cement or plastic glue in
the middle of the roof cover and the
sun roof bracket
Noise
during
staring and
running
The distance between the sun roof glass and Re-adjust the height between the
Chery Service Manual for A520 Body Dimension and Accessories
8
the roof hole is too big or the height of the
glass is incorrect
glasses and their relative positions
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст