Chery A18. Manual — part 65
Assembly moment:9±0.5Nm
3.8. Go under the car to take out the plug of the plug-in unit
on the left & right fog lamps.
3.9. Draw out the bumper and take out the bumper
assembly
4. Assembly steps
4.1.
Assemble according to the inverted sequence of the disassembly
II. Disassembly, assembly & maintenance of the rear bumper
1. Preparation
Tools: Phillips screwdriver, socket wrench 8# & 10#, connecting rod, ratchet wrench, etc.
2. Attentions
2.1. Please put on necessary appliances for labor protection in order to
avoid the accident
2.2. Avoid as much as possible scratching the lacquer surface of the
2.3. When disassembling in the low temperature environment, the
bigger force can not be used for fear breaching the bumper
3. Disassembly steps
3.1. Open the rear door, and unscrew 4 bolts of the rear
bumper with the socket wrench 10#. Shown as the figure:
Moment:
(11±1)Nm
3.2. Separately unscrew fixing screws & bolts of the rear
bumper & rear fender with the socket wrench 8# &
Phillips screwdriver. Shown as the figure:
Moment:
(9±2)N·m
3.3. Draw out the bumper for about 8 cm form the fixing
bracket of the car and take out the plug-in unit of the rear
fog lamp. There are 2 in all. Shown as the figure
3.4. Take out the rear bumper assembly
3.5. Unscrew 4 bolts of the interior bumper with the
socket combined wrench 10#. Shown as the figure:
Attention: Before finish disassembling it, apply the force
to support the bumper in order to avoid falling to hurt
people
Moment:(11±1)Nm
3.6. Take out the interior supporting beam assembly of the
rear bumper.
Shown as the figure
4. Assembly steps
Assemble according to the inverted sequence of the
disassembly
Chapter V Disassembly, Assembly & Maintenance of the
Front Headlamp, Fog Lamp & Tail Lamp
1. Lamp system constitutional diagram
2. Preparation
Socket wrench 10#, open-end wrench 7#, Phillips screwdriver, slotted screwdriver
3. Attentions
3.1. Please put on necessary appliances for labor protection in order to avoid the accident
3.2. Avoid as much as possible scratching the lacquer surface of the bumper when
disassembling
3.3. When disassembling in the low temperature environment, the bigger force can not be
used in order to avoid breaching the bumper, off the controlled switch of the
corresponding lamps and disassemble wires connecting with the accumulator.
3.4. Pay particular attention to the clips on the bumper before disassembling the front
headlamp and the clip can be spoiled if apply the bigger force.
3.5. When disassembling, assembling & putting it, always pay attention to not scratching
the surface of the headlamp.
4. Disassembly steps of the front headlamp
4.1. Open the front compartment cover
4.2. Loosen 2 fixing bolts of the headlamp on the cross
bar of the front compartment with the wrench 10#
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст