Chery A18. Manual — part 51
16
6
Fault code is 00668
Possible reason
[Explanation] The fault code should occur
while voltage supplied by supply terminal 30 is
too high or zero.
l
Fuse of ABS system is blown out
l
Voltage of storage battery is too high or too low
l
ABS electric wiring harness is damaged
l
ABS ECU is damaged
17
7
Fault code is 01130
Possible reason
[Explanation] The fault code should occur while ABS is
disturbed by HF electromagnetic wave, or MP does not
consider that the input speed signal is creditable.
l
Distubance of HF electromagnetic
wave
l
Sensor or wiring harness is damaged
l
ABS ECU is damaged
18
11. Fault inspecting list of faultless code
1
Ignition switch is turned to ON (engine is extinct), while ABS
warning lamp is not light
Possible reason
[Explanation] It might be caused in disconnection of power loop of
warning lamp, burning of bulb, or damage of controller of warning
lamp.
l
Fuse is burned
l
Bulb of ABS warning lamp
is burned
l
Open circuit of power
circuit
l
Controller of ABS warning
lamp is damaged
19
2
ABS warning lamp lights after engine is started
Possible reason
[Explanation] It is possible to be caused in damage of
ABS warning lamp controller or disconnection of ABS
warning lamp loop
l
Warning lamp controller is
damaged
l
Loop of abs warning lamp
controller is disconnected
l
ABS ECU is damaged
Note: The fault format is limited to condition of communication between system and
fault-diagnosing device is available (ABS ECU is supplied normally), and no fault code
occurs.
Abnormal
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст