Chery B11. Manual — part 138
Chery Eastar Service Manual Body Dimension and Accessories
1
Chapter One Engine hood and Luggage Boot
I. Disassembly of Engine hood
1.
Unfasten the fixing nut on the radiator grille and
take out the radiator grille outwards.
2.
Screw out the spring cushion of engine hood.
3.
Loosen the cleaning hose.
4.
Pry out the water spray nozzle.
PDF created with pdfFactory Pro trial version
Chery Eastar Service Manual Body Dimension and Accessories
2
5. Apply the special tool to pry out 12 fixing clips, and
remove the heat shield.
Assemble in the reverse order of disassembly.
Adjustment of engine hood
As the centering bolts are the engine hood hinge fixing
bolts, it is necessary to replace them with the bolts with
washer, or it will be difficult to adjust the engine hood.
Adjust the engine hood in the forward,
backward and vertical direction
Unscrew the hinge bolts in the side of engine hood, and
adjust the hood.
Adjust the engine hood lock
Unscrew the fixing bolts on the hood lock, and adjust the
engine hood lock.
Disassembly of Hood Lock Control Cable:
1.
Disassemble the lower trim of instruments in the left
side of vehicle. (See Disassembly of Instrument
Panel)
2.
Disassemble the lining of left fender. (See
Disassembly of Fender)
3.
Remove the hood lock, loosen and take out the cable.
Assemble in the reverse order of disassembly.
Assembling requirements: The adjustment of front hood
lock shall ensure that the clearances around the front hood
are uniformly 9±l mm, with uniform height:
The tightening torque of front hood lock bolts is 14±2 N·m.
PDF created with pdfFactory Pro trial version
Chery Eastar Service Manual Body Dimension and Accessories
3
Disassembly of Luggage Compartment Door
1.
Pull out the car floor mat.
2.
Unclip the clip of left side shroud.
3.
Apply the clip remover to disassemble the wiring
clip, and uncouple the wiring harness.
4.
Remove four bolts and the door.
For assembly, its procedure is opposite to that of
disassembly.
PDF created with pdfFactory Pro trial version
Chery Eastar Service Manual Body Dimension and Accessories
4
Replacement of Luggage Boot and Hinge
1.
Remove the rear seat assy. (See Disassembly
/Assembly of Seat).
2.
Disassemble the rear package tray assy. (See
Disassembly of Rear Blind--Brake Lamp).
3.
Remove
the
four
bolts
of
luggage
compartment door, and support the boot
door.
4.
Remove the six fixing bolts from the rear
package tray.
Disassembly of Luggage Compartment
Door
1.
Disassemble the lock core
①
Disconnect the connecting rod from the lock
core.
②
Loosen
the fixing bolts, and take out the
lock core.
2.
Disassemble the luggage boot lock
①
Take out the clip and detach the connector
plug of motor
PDF created with pdfFactory Pro trial version
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст