Chery B11. Manual — part 139
Chery Eastar Service Manual Body Dimension and Accessories
5
②
Loosen the two screws of door lock and remove
the luggage boot lock.
③
Remove the license plate.
④
Remove four fixing bolts and one screw from the
license plate, and detach the bracket.
⑤
Unscrew the fixing screw on the chromed
moulding, and remove the chromed moulding.
PDF created with pdfFactory Pro trial version
Chery Eastar Service Manual Body Dimension and Accessories
6
3.
Disassemble the license lamp
① Unscrew the clip screw, and take out the clip.
② Unclip the harness clip and pull out the harness
insert and remove the licence lamp.
4.
Disassemble the trim rear cover.
Unscrew the four fixing screws, and remove the
two clips.
Assemble in the reverse order of disassembly.
Assembling requirements: The adjustment of luggage boot lock shall ensure that the left/right
clearance between the boot cover and rear side of vehicle is uniformly 5±0.5 mm, and its height shall
also basically uniform with error Φ of 0.5 mm. and the tightening torque of set screw is 9±1 N·m.
Luggage boot wheelhouse left/right trim assy. The contact part between the periphery of carpet and
luggage boot weather seal shall be wrapped in the lip of weather seal, and both match well. The
contact part with the upper shield of C column shall be placed inside the shield. And any part of the
trim assy. shall be assembled in its proper position, which adheres perfectly to the body of a vehicle.
The clips of luggage boot carpet shall be placed just in the gap of luggage compartment rear trim. Its
two sides shall attach tightly to the edge fold of luggage boot wheelhouse left/right trim. And it shall
adhere perfectly to the rear floor of body after assembly.
Disassembly of Rear Luggage Compartment Weather Strip:
1.
Loosen the harness of rear luggage compartment door.
2.
Unscrew the four fixing bolts of rear boot door hinge (and make a note of marking).
PDF created with pdfFactory Pro trial version
Chery Eastar Service Manual Body Dimension and Accessories
7
3.
Remove the rear boot weather seal.
Assemble in the reverse order of disassembly.
When assembling, take care that the joint of luggage boot weather seal shall be placed in position of
luggage boot lock. Any corner shall be assembled to its proper position, and it is prohibited that the
folding occurs. The weather seal shall have appropriate hardness, and does not change considerably
with the change of temperature.
PDF created with pdfFactory Pro trial version
Chery Eastar Service Manual Body Dimension and Accessories
8
Chapter Two Exterior Accessories
Disassembly of Front Wheel Mud Guard
l. Loosen the three fixing bolts, and remove the
front wheel mud guard.
2. Unscrew the two fixing screws of rear wheel mud
guard, and remove the mud guard.
Assemble in the reverse order of disassembly.
Disassembly of Front Fender
1.
Disassemble the headlamp
① Remove the three fixing bolts
PDF created with pdfFactory Pro trial version
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст