Chery B11. Manual — part 147
Chery Eastar Service Manual Body Dimension and Accessories
39
8. Raise the trim panel towards the exterior of
vehicle and pry it out with a screwdriver.
9. Detach the control cable on the inner handle,
and remove the trim panel.
Assemble in the reverse order of
disassembly.
Measures shall be taken to prevent the working area rinsed from being dirtied during disassembly and
assembly. It is very important to keep clean when conducting these operations.
Assembling requirements: The fit clearance between the door panel and door inner panel shall be
uniform, and the torque of fixing screw shall be 3±0.5Nm. The rinsing width of front/rear windshield
shall be between 15 to 17 mm. the width of primer between 13 to 15 mm. the width of adhesive
between 7 to 9 mm and its height 9 to 15 mm, without any adhesive leakage, overflow liquid and etc
after assembly. the clearance between the upper and lower of glass and that between the left side and
right side shall be identical and uniform to ensure that they match well with the adhesive strips around
them. And the glass shall be sealed well, and there is no any leakage and other defects after rain test.
Disassemble the Speaker Assy.
Unscrew the four fixing bolts, and remove the audio horn.
PDF created with pdfFactory Pro trial version
Chery Eastar Service Manual Body Dimension and Accessories
40
Door Weather Seal
Disassembly and Assembly
While pulling the weather seal by hand, apply the
clip disassembling tool to remove all clips, and
then take out the weather seal.
All corners shall be assembled into their proper
positions during assembly without wrinkle.
The fit of weather seal with the body shall be
with a certain clamping force, without falling
down easily.
Disassemble the Inner Handle
Unscrew the five fixing bolts on the inner handle,
and remove the inner handle.
Disassemble the Peach Plate
Unscrew the eight fixing bolts on the peach plate
and remove the peach plate.
PDF created with pdfFactory Pro trial version
Chery Eastar Service Manual Body Dimension and Accessories
41
Rear Door Glass and Glass Run Channel
Disassembly and Assembly
l.
Unscrew the two fixing bolts on the glass bracket, and remove the glass.
2.
Pull out the glass run channel.
Assemble in the reverse order of disassembly.
Assembling requirements: All corners all be assembled in their proper positions during assembly
without wrinkle. The joint of weather seal shall be placed in the middle position under the door
opening. The hardness of weather seal shall be appropriate, and not change considerably with the
change of temperature. The surface of adhesive strip shall have no defect such as stamping mark,
deformation, warpage and etc, after assembly. The one end of platen of front doorsill platen assy. shall
match well with the contact part of lower shield of A column or B column. The platen shall be
assembled in its proper position, without looseness and other phenomena. And the carpet has no
exposure and other defects after assembly.
Window Regulator and Motor Assy.
Disassembly and Assembly
l.
Remove the glass.
2.
Remove the seven fixing nuts on the assy..
PDF created with pdfFactory Pro trial version
Chery Eastar Service Manual Body Dimension and Accessories
42
3.
Remove the trim panel fixed support.
4. Loosen the motor harness connector, and
remove the window regulator assy.
5. Take care to add lubricating oil to the slide
block, and check there is no burr after
adjustment.
PDF created with pdfFactory Pro trial version
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст