Chery B11. Manual — part 17
Light Control
69
Switch connects with
gating system
automatically. The cabin
light will be on when the
door is opened (the
switch is placed on gating
position). The cabin light
remains lighting for 8
seconds when the door is
closed (convenient for
passengers Rear
roof light
OFF position: light switch off.
ON position: light remains on.
Middle (gating) position: the cabin light is
switched on with the door opened. The
cabin light remains on for 8 seconds when
the door is closed (convenient for
passenger to sit).
Luggage boot lamp
The light is on with boot hood opened
(this light without control by
ignition switch). Please pay attention to
close the boot hood when stopping.
The light is also to be OFF status (not to
be switched on with boot hood opened)
with pressing the trigger switch to locked
position. You must release the trigger
switch if you want to turn the light on.
Lighting of
sun visor/vanity mirror
Opening the cover of vanity mirror to
switch on the light of vanity mirror.
Front doorsill light and
key-hole light
The key-hole light and front doorsill light
will be on with front door open.
The front doorsill light is placed in the
interior decoration panels of both front
doors. If open the doors, doorsill light will
be switched on to lighted foot region and
Light Control
70
direct driver whatever ignition switch is on
or not. This light will be switched off
when the door is closed.
Key-hole light is installed around the
ignition key-hole. The light will be
switched on to help the driver insert
ignition key, if any front door is opened.
This light will be switched off when the
key is turned to “ON” position.
Hazard warning flasher
switch
Only use it in an emergency, to warn the
following vehicles. Press the switch down
to switch on/off this system. This hazard
warning flasher is also illuminated even
the ignition switch is switched off.
The button indicator light flashes, when
warning flasher is switched on. The turn
signal lamp will also flash on the
instrument panel, when the ignition switch
is on.
Operation and Adjustment of Interior Devices
71
Interior devices operation and adjustment
Operation and Adjustment of Interior Devices
72
Steering
wheel
lock/
ignition switch
Steering wheel lock/ignition switch
includes the following key positions:
LOCK – the ignition is switched off, and
steering wheel is locked.
After removing the key, turn the steering
wheel slightly to the left or right until you
hear the lock engage.
ACC - Steering system unlocked.
Individual electrical equipments and
accessories are available for use. But
ignition switch and primary electrical loop
are not available for use.
If it is not able (or hard) to turn ignition
key to ACC position from LOCK position,
you can move the steering wheel slightly
to help disengage the locking mechanism.
To avoid exhausting the power of storage
battery, ignition switch should be not in
this position for a long time.
ON– To switch on the ignition circuit, all
electrical equipment and accessories are
available for use. And caution lights and
indicator lights are switched on. This is the
correct position of the key for driving. And
it is also the requested position for towing
vehicle.
START - Switch on the motor to start the
engine.
When the key-hole is on this position, the
front headlamps and power-waste
electrical equipments are cut off.
There is prevention of repeat-starts unit in
the ignition switch. Once the engine starts
this unit can prevent the engine
mis-starting and avoid damaging the
engine and its flywheel.
If you fail to start the engine, release the
ignition key to LOCK position and turn
back again before next starting. Let it go
to release the ignition key toON position
after starting.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст