Chery B11. Manual — part 58
Maintenance Manual for Chery·Oriental Son
Engine Section
Balance axle rear bearing disassemble
MB991603
Disassemble left balance axle rear bearing
with special tool from cylinder body.
Remarks:
Special tool (MB991603) should be installed
in front of cylinder body when disassembling
left balance axle rear bearing.
MB998372
Installation Notice
Right balance axle rear bearing installation
(1) Daub oil on bearing surface.
(2) Install right rear bearing with special tool.
Make sure that oil holes on bearing and
cylinder body are aligned.
MD998705
MB991603
Left balance axle rear bearing installation
(1) Install special tool (conducting board) on
cylinder body.
(2) Daub oil on rear bearing edges and inside
cylinder body bearing holes.
MD998705
Rear
bearing
MB991603
(3) Install rear bearing with special tool
Remarks:
There is no oil hole in left rear bearing.
MD998705
Maintenance Manual for Chery·Oriental Son
Engine Section
Balance axle front bearing installation
Install front bearing with special tool
MD998705
MD998705
Bearing
Cylinder
body
Front cover installation
(1)Install special tool on crankshaft front end .
daub oil slightly on the exterior circle
surface of special tool and then install front
cover
MD998285
(2)Use new front cover oil seal cushion and
install front cover component. Tighten
flange bolt temporarily (Except for oil
cleaner bracket locking bolt)
MD998285
Balance axle oil seal installation
Socket
wrench
Press oil seal into front cover with socket
wrench.
Front
cover
Oil seal
Maintenance Manual for Chery·Oriental Son
Engine Section
socket wrench
Oil pump oil seal installation
Oil
seal
Press oil seal into front cover with socket
wrench.
Front
cover
前盖
Crankshaft front oil seal installation
MD998375
Install crankshaft oil seal on front cover with
special tool.
Oil
seal
Front
cover
Fitting mark
Oil pump driven/drive gear installation
Daub oil on gear surface and align the
fitting marks.
Daub sealant on oil pressure switch
Daub sealant on oil pressure switch screw
thread parts and then install the said switch
with special tool.
Special sealant: 3M ATV or relevant
equivalents.
Caution:
·Keep the top of screw thread clean
and do not daub sealant.
· Excessive tightening should be
avoided.
Maintenance Manual for Chery·Oriental Son
Engine Section
Flange bolt installation
(1)Insert cross screwdriver into the hole in the
left side of cylinder body and lock balance
axle.
Screwdriver
(2)Tighten flange bolt with specified torque to
ensure driven gear of oil pump is fixed on
left balance axle.
Plug installation
(1) Install O-shape ring in front cover slot.
(2) Install plug with special tool and tight it to
specified torque.
MD998162
Oil pan installation
MD998783
(1) Keep the fitting surface of oil pan and
cylinder body clean.
(2) Daub 4mm-diameter sealant on the edge
of oil pan flange surface.
Specified sealant:
Mitsubishi pure product MD970389 or
relevant equivalents.
Remarks:
(1) Install oil pan quickly when sealant is
still wet (about 15 minutes)
Slot
section
Bolt hole
section
(2) Do not make the sealed part bedewed
with oil in an hour or so after
installation.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст