Chery B11. Manual — part 59
Maintenance Manual for Chery·Oriental Son
Engine Section
Crankshaft pulley side
(3) Confirm the bolt length and their
installation locations are a little different.
8mm-length bolt
Oil pan bottom
view
Drain plug cushion installation
Install drain plug cushion according to the
direction as shown.
Caution:
Oil pan side
The incorrect installation direction may
result in oil leakage.
Drain plug
cushion
Oil cleaner installation
(1) Make installation surface of oil cleaner
bracket clean.
Bracket side
(2) Daub engine oil on O-shape ring of oil
cleaner.
(3) Screw on oil cleaner. When the O-shape
ring reaches installation surface, screw
3/4 cycle further. (Tighten torque:
1.4kg.m)
Check
Front cover
(1) Check if oil hole is jammed. If necessary,
clear it up.
(2) Check if there is abrasion, damnification
or sinter on left balance axle front bearing.
If necessary, replace front cover.
(3) Check if there is crack or other
damnification. If any, replace front cover
component.
Oil seal
(1)
Check if there is abrasion or
damnification on oil seal lip. If necessary,
replace oil seal.
Maintenance Manual for Chery·Oriental Son
Engine Section
(2) Check if there is deterioration
on oil seal lip. If necessary,
replace oil seal.
Maintenance Manual for Chery·Oriental Son
Engine Section
Balance axle
(1) Check if oil hole is jammed.
(2)
Check if there is sinter,
damnification or
interposition of
bearing.
If any badness, replace
balance axle, bearing or front
cover component.
Oil pump
(1) Install oil pump gear on front
cover and then screw on the
gear. Check if it can rotate
smoothly and is tightened.
(2) Ensure there is no
ridge shape
abrasion
on the contact surface
of front cover and oil pump
cover gear surface.
(3) Check side clearance.
Standard value:
Drive
gear
0.08-0.14mm
Driven
gear
0.06-0.12mm
Maintenance Manual for Chery·Oriental Son
Engine Section
Chapter 6 Cooling System
Intake Manifold, Water Pump
Remove Steps:
1. Water soft tube
2. Water soft tube
3. Engine coolant temperature sensor
4. Engine coolant induction plug
5. Inflow tube joint
6. Thermostat
7. Thermostat shell
20N.m
8. Inflow Tube
9. O-shape seal ring
10. Water pump
11. Water pump seal ring
12. Oil gauge
13. Oil gauge duct
14. O-shape seal ring
15. Manifold bracket
16. Intake manifold
17. Manifold gasket
18. Engine flying ring
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст