Chery B11. Manual — part 31
Emergency Handling
125
Notice:
Halogen bulb must be in fix position in
the bulb holder.
Front Turn Signal Bulb
1.
Turn the bulb holder
counter-clockwise and remove it.
Press down the defective bulb
slightly, turn it counter-clockwise
and remove it for replacement.
2.
Install the new bulb in the reverse
sequence.
Position Lamp
Follow the instruction of front turn signal
to replace position lamp bulb.
Side turn signal (on the
outside rearview mirror )
Please have it replaced by Chery Service
Service Center
Front Fog Lamp
When changing the front fog lamp bulb,
the vehicle should be lifted. For this
reason, have it changed at Chery Special
Service Center.
Tail Lamp
1.
Open the rear trunk, from inside the
trunk, remove the tail lamp assembly
lock and take the assembly out.
2.
Remove the bulb holder as opposed
to the tightening direction indicated
on it.
3.
Press down the bulb slightly and turn
counter-clockwise to remove the
bulb for replacement.
Emergency Handling
126
4.
Install the new bulb in the reverse
sequence.
5. Check whether the tail lamp
assembly work normally after
installation.
High Brake Lamp
1.
Open the rear trunk, remove the two
cross-screws and remove the cover.
Disconnect the wire and remove the
defective bulb for replacement.
2.
Install the new bulb in the reverse
sequence.
license plate lamps
Location: Below the license plate cover
1.
Remove the self-driven screw which
fasten the license plate and take it
off.
2.
Pull out the bulb holder and remove
the defective bulb.
3. Place the new bulb in the bulb
holder and install the bulb holder.
4.
Fasten it with self-driven screws.
Interior Roof Lamp
1.
Turn off interior lamp.
2. Insert a screw driver in between
lamp cover and the bulb holder, pry
the holder out carefully.
3.
Replace the bulb, install the mirror.
4.
Put the bulb holder back to within
the cover.
Vanity Lamp on Sun Visor
Behind the sun visor.
Pry out the mirror glass and replace the
bulb.
Trunk Lamp
Location: In the cover of left-rear speaker.
1.
From behind the lamp, press A part
of it and remove it.
2. Replace the bulb.
3. Fasten it back to the holes in the
speaker cover.
Emergency Handling
127
Adjust Head Lamp
Whether head lamp is adjusted correctly is
directly related to your safety. For this
reason, only specialized equipment should
be used to do the work. Comply to legal
requirement for the adjustment.
The position of the head lamp must be
suitable for the load of the vehicle.
Screw A : Vertical adjustment
Screw B : Horizontal adjustment
The figure shows the adjustment of the
right head lamp. Remove the cover when
doing the adjustment.
Adjustment of the left head lamp is
symmetrically same as the right one.
Fuse and Electrical
Distributor
Shut off engine and all
electrical equipment before
replace fuse and electrical
distributor.
Replace the fuse with one with the same
ampere rating. The fuse and electrical
distributor box is located as indicated in
the figure.
Replacement of electrical distributor
requires specialized knowledge.
A few of spare fuse is recommended to be
kept in the vehicle just in case.
Chery Special Service Center provides all
types of fuses.
Melted fuse can be easily discerned. Fuses
provided by Chery are all “push-and-fix”
style.
Small Fuse
A
Emergency Handling
128
Melting Tube
Any unauthorized
modifications in the electrical or fuel
system can influence performance of
your vehicle and might lead to fire
or other danger. For this reason
replacement of electrical and fuel
system components should be done
by Chery technicians only.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст