Chery Tiggo T11 LHD. Manual — part 24

T11 Service Manual Chassis System

e. Unscrew the fixing bolts of right and left

hand brake cable.

f. Remove the hand cable from the actuator of

brake.

Hint: the installation procedure is opposite to that of removal!

Remark: the parking brake shall be adjusted after replacing brake shoes or hand brake cable.

□ Loosen the parking brake handle.
□ Forcibly step on brake pedal once.
□ Pull the parking brake handle up by four teeth.
□ Tighten the adjusting nut till the two wheels cannot be turned by hand.
□ After completing the above procedures, loosen the parking brake to inspect the two rear

wheels to see whether they can be turned freely. Otherwise the above process of

adjustment shall be repeated.

T11 Service Manual Chassis System

Ⅴ Removal of Brake Master Cylinder

1. Removal of Brake Master Cylinder

a. Disconnect the electric joint of fuel level gauge.

b. Drain the brake oil via suction hose.

Remark: avoid splashing brake oil onto skin or vehicle finish, as it has comparatively strong

corrosiveness!

c. Loosen the brake lines of brake master

cylinder.

d. Remove the liquid reservoir.

Remark: straightly push the liquid reservoir body

upwards so as to dismount is from the master

cylinder body. And then remove O-ring from the

reservoir flute. Inspect the liquid reservoir to avoid

crack or deformation, and replace it if necessary.

Then clean the reservoir via denatured alcohol.

Finally dry the liquid reservoir by oil free

compressed air.

e. Unscrew the retaining nut of brake master

cylinder.

T11 Service Manual Chassis System

2. Disassembly of Brake Master Cylinder

a. Refer to the removal instruction to remove

the brake master cylinder.

b. Clean the liquid reservoir cover.

c. Remove the liquid reservoir cover and

membrane element.

d. If there exist the following damages, please replace liquid reservoir cover and membrane

element 3.

□ Kerfs
□ Rupture
□ Scratch
□ Deformation

e. Remove the liquid reservoir of master cylinder.

f. When removing the clamp holder, in the mean time, the primary piston shall be pressed

downward. Be cautious to avoid damaging the following parts:

□ Piston
□ Cylinder sleeve
□ Groove of clamp holder

g. When other external tapping is jammed, please feed low-pressure and non-lubricated

compressed air into the upper outlet of hole closed-end. When removing the following parts,

the above described operation procedures must be performed.

□ Primary piston
□ Auxiliary piston
□ Spring
□ Spring retainer

h. Remove the seal and spring retainer from the secondary piston.

i.

Inspect the master cylinder to avoid scratch or erosion, if damage occurs, please replace the

master cylinder. And never employ abrasive in the holes.

j.

Clean all of parts in uncontaminated denatured alcohol.

T11 Service Manual Chassis System

k. Dry the parts by oil free compressed air.

Remark: the installation procedure is opposite to that of removal!