Chery Tiggo T11 LHD. Manual — part 23
T11 Service Manual Chassis System
Ⅳ Installation of Parking Brakes
1. Replacement of Parking Brake Shoes
1) Removal
a. Remove the tire.
b. Remove brake caliper, and refer to the section of "Disc brake" to replace the bracket of brake
caliper.
c. Refer to the replacement of brake disc to remove rear brake disc.
d. Remove the rear wheel hub units.
Remark: properly align the four holes in the
brake hub units to the corresponding fixing
bolts of brake elements.
e. Remove the actuator of parking brake.
f. Remove the brake shoes.
T11 Service Manual Chassis System
2) Installation
a. Fix the brake shoes and linings.
Note: Ensure brake shoes and parking
brake is well engaged.
b. Install the actuator of parking brake
c. Refer to the replacement of wheel
bearing/hub of rear suspension to install
rear wheel hub.
d. Adjust the rear parking brake shoes.
e. Refer to the replacement of brake disc to
install rear brake disc.
f. Refer to the replacement of brake caliper
bracket in disc brake to install rear
caliper bracket.
g. Adjust the parking brake.
2. Adjustment of Parking Brake Shoes
Necessary adjusting tools
J21177-A gap gauge for brake drum and brake shoes
a. Refer to the replacement of brake caliper
bracket in disc brake to remove caliper
bracket.
b. Remove the brake disc.
When pulling out the brake disc from wheel
hub, please slowly turn the brake disc.
c. Loosen the adjusting nut on the cable of
parking brake to keep the bar at a stop
position.
T11 Service Manual Chassis System
d. Adjust J21177-A to contact the inside
diameter of brake disc.
e. Put J21177-A at the widest area of the
clearance between brake shoe and lining.
f. Turn the adjusting nut till the brake shoe
and lining 1 barely contact J21177- A.
g. With respect to the brake disc of the opposite side, please repeat the above-mentioned
procedure 2 to 5.
h.
Adjust the adjusting nut on the cable of rear parking brake, and then install brake disc and
brake caliper.
3. Replacement of Parking Brake Cable
(1) Fixing bolt of hand brake maneuver mechanism
(3) Hand brake front cable assembly
(2) Hand brake maneuver mechanism assembly
(4) Hand brake cable assembly
T11 Service Manual Chassis System
a. Remove the handrail case.
b. Loosen the adjusting bolt of hand brake.
c. Loosen the fixing bolts of right and left
cable.
d. Loosen the hand brake cable.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст