Chery QQ6 (S21) / S12LHD. Manual — part 19
73
3. Installation of Evaporator Assy
The installing steps are reverse to those for
removal.
4.
Disassembly/Reassembly
of
Evaporator Interior
Preparation of tool(s): cross screwdriver, socket
wrench
4.1. Removal Step
4.1.1. Refer to the Removal of Evaporator Assy,
and take off the evaporator assy.
4.1.2. Remove the harness and connector from
the evaporator.
4.1.3.
Remove
three
screws
from
the
intermediate part of the evaporator, and
partition the evaporator into two parts.
4.1.4. Remove the air direction regulating
mechanism from the distributor with a cross
screwdriver (as shown in the figure).
Torque: 1.5±0.5 Nm
74
75
4.1.5. Remove eight housing connection screws
from the distributor with a cross screwdriver (as
shown in the figure).
Torque: 1.5±0.5 Nm
4.1.6. Detach the distributor. In this case, take
off the air baffle from the interior.
4.1.7Remove four fix screws from the air inlet
with a cross screwdriver, and take off the air
inlet.
Torque: 1.5±0.5 Nm
4.1.8 Remove the fixing screws from the
inner-outer recirculating air control mechanism
with a cross screwdriver, and then take off the
inner-outer recirculating air control mechanism.
Torque: 1.5±0.5 Nm
76
4.1.9. Remove nine housing connection screws
from the other side of the evaporator with a
cross screwdriver (as shown in the figure).
Torque: 1.5±0.5 Nm
4.1.10. Remove four screws from two fixed
iron sheets of A/C heater pipe with a cross
screwdriver.
4.1.11. Remove two clips from the evaporator
with a flat head screwdriver.
4.1.12. Separate the upper part of the housing
from the lower part by both hands.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст