Chery QQ6 (S21) / S12LHD. Manual — part 18
69
2.1.3. Remove the four fix screws from both
sides of instrument panel and cross beam with a
cross screwdriver.
Torque: 3±1 Nm
2.1.4. Take off the cross beam and air duct.
2.1.5. Remove two screws used to fasten the air
duct from the cross beam with a cross
screwdriver.
Torque: 3±1 Nm
70
2.1.6. Take off the air duct, and detach the
harness as required.
2.2. Installation Step
Refer to Removal Step and install it in reverse
order.
71
Chapter 8 Air Conditioning (A/C) System
I. System Composition
Air adjustment and distributing system: HVAC air mixing and distributor part, inside/outside
circulation air inlet, air outlet, outside circulation air filter.
Control system: control panel assy, wire drawing, micro-motor, fan, resistor, high/low voltage switch
Heating system: heater, hot water pipe, engine cooling water system.
Cooling system: compressor, condenser, reservoir dryer, expansion valve, evaporator, and pipe.
II. Removal of Evaporator Assy
1. Preparation
Tool: cross head screwdriver, carp pliers, socket
spanner
Auxiliary material: refrigerant, antifreeze,
sponge rubber strip
2. Disassembly/Reassembly Step
2.1 Recycling the refrigerant by refrigerant
recycling machine
Note:
(1) DO NOT dispose the coolant in a sealed
location or near fire.
Condenser Assy
HVAC Assy
Control Panel Assy
Dry Fluid Reservoir Assy
A/C Compressor Assy
Condenser Assy
4 Pipes Assy
72
(2) Do not splash the refrigerant into eyes and
skin.
2.2. Disassemble instrument panel assy and
front cross beam. Pull out the related electrical
connectors.
2.3. Loose fixing bolts on high/low pressure
pipe with spanner.
Torque: 5±1 Nm
2.4. Loosen two fixing bolts used to connect the
high/low pressure pipe to the expansion valve,
and pull outwards the high/low pressure pipe.
Torque: 8±1 Nm
2.5. Loosen three fixing bolts of evaporator and
front side.
Torque: 3.5±0.5 Nm
2.6. Remove the inlet/outlet pipe snap rings
from the evaporator radiator with a plier, and
pull out the water pipe.
CAUTION: The coolant may flow out from the
water pipe, and pay attention to the recovery of
coolant.
2.7. Loosen six fixing bolts of evaporator assy
fixed on the paintwork from the engine
compartment, and the fixed position is as
shown in the right figure.
Installation torque: 5±0.5 Nm
2.8. Take out evaporator and AC cable assy
from cab
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст