Chery QQ6 (S21) / S12LHD. Manual — part 169
Section IX Tail Door Harness
I. Harness Sketch
搭铁
To
in-door
harness
High
mounted
brake light
Trunk switch
To
defroster
positive harness
Ground
Rear wiper motor
II. Instructions on Main Connectors
III. Removal and Installation of Tail Door In-door harness
Part number: S12-3724160
(I). Preparations
Tools: sleeve wrench, cross head screwdriver, flat head screwdriver
(II). Notes
1. Do not use too much force when getting the harness through the hole in the vehicle body plate work, or the
harness may get damaged and result in short circuit.
2. When disassembling the electrical components and harness, please disconnect the power supply.
3. The ignition switch must be OFF.
(III). Removal and Installation Steps
1. Removal
1.1.1. Use a cross head screwdriver to remove the left C-pillar inner
shield.
(See Removal of Vehicle Body Accessories)
1.1.2. Unplug the harness plug forming abutt-joint with the in-door
harness.
No
Connector Name
Pins
Connection
Remark
1
To in-door harness connector
6
In-door harness
2
High
mount
brake
light
connector
2
High mount brake light
3
Trunk switch connector
2
Trunk switch
4
To defroster positive harness
connector
2
Defroster positive harness
5
Rear wiper motor connector
3
Rear wiper motor
6
Ground
1
Vehicle body plate work
On the tail door plate
work
1.1.3. Disassemble the high mount brake light shield by hand.
1.1.4. Unplug the harness plug connecting the high mount brake
light.
1.1.5. Use a flat head screwdriver to disassemble the tail door shield.
1.1.6. Unplug the rear defroster positive harness plug.
1.1.7. Unplug the trunk switch plug.
1.1.8. Unplug the rear wiper motor plug.
1.1.9. Disassemble the vehicle body ground wire. (On the tail door)
1.1.10. Removal of tail door in-door harness
2. Installation
The installation steps are reverse to those for removal, and special
auxiliary tools (thin steel wire) can be used to accomplish it.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст