Chery QQ6 (S21) / S12LHD. Manual — part 130

4. Removal & Adjustment of of Front Hood Assembly

Preparation of Tools: 13# sleeve, wheel wrench and extension bar
4.1. Turn and remove the four adjusting bolts off the front hood, and
then the front hood can be taken down. And the positing of the front
hood can be adjusted in all directions by loosening the four
adjusting bolts.






4.2. Installation of Front Hood Assembly:
The installation steps are reverse to those for removal.
Installation torque is 29±3Nm

5. Removal and Installation of Air Inlet Grid Assembly

5.1. Removal Steps

5.1.1. Use the wrench to remove the four fastening screws on the Air
Inlet Grid assembly as shown in the picture.





5.1.2. Remove the Air Inlet Grid.

5.2. Installation Steps

The installation steps are reverse to those for removal.
Installation torque is 5±0.5Nm

6. Removal of Front Hood Lock

6.1. Removal Steps

6.1.1. Turn and remove two screws off the front hood to take down
its lock.








6.1.2. Remove the front hood lock cable off the front hood lock
assembly.

6.2. Installation Steps

The installation steps are reverse to those for removal.

7. Removal & Adjustment of of Hood Cable

7.1. Removal & Adjustment of Steps
7.1.1. Remove the plastic nut behind the front hood handle in
driver’s cab.And you can also regulate the cable by adjusting this
nut.

7.1.2. Use snipe nose pliers to remove the front hood cable off the
pull cover.








7.1.3. Drag out the cable.

7.2. Installation Steps

The installation steps are reverse to those for removal.

II. Removal of Rear Trunk Cover

1. Preparations

Tools: flat head screwdriver, 13# sleeve, wrench and cross head
screwdriver
Material(s): Clip

2. Removal of Rear Decoration Plate

2.1. Pry up the rear decoration plate with a flat head screwdriver
before you take it apart.








2.2. Installation of Rear Decoration Plate
The installation steps are reverse to those for removal.

3. Removal and Installation of Trunk Lock

3.1. Removal Steps

3.1.1. Remove the pull rod off the upper lock.








3.1.2. Pull off the connector on top of the upper lock.












3.1.3. Use a cross head screwdriver to remove the three screws on
the upper lock.














3.1.4. Remove the trunk lock.