Chery QQ6 (S21) / S12LHD. Manual — part 131

3.2. Installation Steps

The installation steps are reverse to those for removal.
Installation notes: Is the lock column deformed? Is the riveting
adequate? Is the lock jacket on the trunk in good condition? Or can
the lock tongue open and shut freely?

4. Removal of Trunk Lock Cylinder

4.1. Removal Steps

4.1.1. Disengage the hitch bar from the lock core.







4.1.2. Pry open the clip on the lock core with a flat head screwdriver.








4.1.3. Push up the lock core to take it out.
Note: Do not throw away the washer of the lock core.

4.2. Installation Steps

The installation steps are reverse to those for removal.
Pay attention to assemble it to its correct position and joint to door
plate work.

5. Removal of Rear Wiper Nozzle

5.1. Removal Steps

5.1.1. Pry open the shield of the high mount ceiling light with a flat
head screwdriver.







5.1.2. Pull off the connector, and then use a cross head screwdriver
to remove the two screws on the high mount ceiling light and take it
down.















5.1.3. Remove the two nuts on the spoiler with 10# sleeve.

5.1.4. Remove the spoiler.








5.1.5. Pull off the rear water nozzle (You can pry with a flat head
screwdriver, but try to avoid any paint scratch), and then pull off the
water nozzle hose.

5.2. Installation Steps

The installation steps are reverse to those for removal.
Note: Water injection opening should be opposite to wiper motor
steering shaft.

6. Removal of Rear Wiper Motor

6.1. Removal Steps

6.1.1. Remove the rear wiper shield by hand.







6.1.2. Use a 10# sleeve wrench to loosen off the nut above the
motor, and remove the rear wiper blade.
Installation torque is 12±2Nm

6.1.3. Remove the three fixing bolts on the rear wiper motor.
Installation torque is 12±2Nm









6.1.4. Remove the motor.

6.2. Installation Steps

The installation steps are reverse to those for removal.