Chery QQ6 (S21) / S12LHD. Manual — part 160
127
2.1.11. Disassemble the power steering pump connector.
2.1.12. Disassemble the knock sensor connector.
2.1.13. Disassemble the reverse light switch connector.
2.1.14. Disassemble the water thermostat connector.
2.1.15. Disassemble the front/rear oxygen sensor connector. Simply
pull out the red lid on the connector as shown in the figure.
128
2.1.17. Disassemble the vehicle speed sensor connector.
Use a flat head screwdriver to pry open the clips on the connector
and then pull it out.
2.1.18. Disassemble the engine rotation speed sensor connector.
2.1.19. Take out the electronic fuel injection harness assembly.
2. Installation of harness
The installation steps are reverse to those for removal..
Section IV In-door Harness:
I. Harness Sketch
LR group tail lamp
Butt joint with back
door
Butt joint with LR
door
BCM module A
Seat belt switch
LF door contact
switch
License plate lamp
LR loudspeaker
To abut joint with
instrument harness
Trunk light
Ground
Fuel pump
RR wheel
ABS
sensor
Abut joint
with
instrument
harness
Ground
Hand brake switch
Abut joint with
left front harness
(1)
Ceiling light
Dormer
controller
Ground
Cab interior
abut
joint
with
right
front
door
(1)
RR
wheel
ABS
sensor
Cab
interior
abut joint with
right rear door
RR group tail lamp
RR
door
contact
switch
RF
door
contact
switch
Rear loudspeaker
BCM module B
Ground
Cab interior
abut
joint
with
right
front
door
(2)
To
front
compartment
Harness
Abut joint with
left front harness
(2)
Ground
RR
door
contact
switch
Reverse radar
power
III. Instructions on Main Connectors
No
Connector Name
Pins
Connection
Remark
1
License plate lights connector
2
License plate lights harness
2
Left-rear combination tail light connector
10
Left-rear combination tail light harness
3
Trunk light connector
2
Trunk light harness
4
Left-rear speaker connector
2
Left-rear speaker harness
5
Fuel pump connector
4
Fuel pump harness
6
Right-rear speaker connector
2
Right-rear speaker harness
7
Right-rear combination tail tights connector
6
Right-rear combination tail lights harness
8
BCM Module A connector
BCM Module B connector
16
25
BCM Module A harness
BCM Module B harness
9
Hand brake switch connector
1
Hand brake switch harness
10
Ceiling light connector
6
Ceiling light harness
11
Seat belt switch connector
2
Seat belt switch harness
12
Connect the instrument harness butt joint
26
Butt jointed with instrument harness
13
Butt jointed with instrument harness
4
Butt jointed with instrument harness
14
To front compartment harness connector
16
To front compartment harness
15
Left-rear wheel ABS sensor connector
2
Left-rear wheel ABS sensor harness
16
Right-rear wheel ABS sensor connector
2
Right-rear wheel ABS sensor harness
17
Reverse radar power connector
2
Reverse radar power harness
18
Butt jointed with tail door harness
6
Butt jointed with tail door harness
19
Ground
1
Connected with ground wire
Inside the left C-pillar
inner shield
20
Left-rear door contact switch connector
1
Left-rear door contact switch harness
21
Right-rear door contact switch connector
1
Right-rear door contact switch harness
22
Ground
1
Connected with ground wire
Inside the right C-pillar
inner shield
23
Connector to front door harness butt joint 1
10
Front door harness butt joint 1
24
Connector to front door harness butt joint 2
14
Front door harness butt joint 2
25
Connector to interior and right-front door
butt joint 1
6
Interior and right-front door butt joint 1
26
Connector to interior and right-front door
butt joint 2
10
Interior and right-front door butt joint 2
27
Right-front door contact switch connector
1
Right-front door contact switch harness
28
Left-front door contact switch connector
1
Left-front door contact switch harness
29
Forming butt-joint with left-rear door
harness
10
Forming butt-joint with left-rear door
harness
30
Interior forming butt-joint with right-rear
door
10
Interior forming butt-joint with right-rear
door
31
Ground
1
Connected with ground wire
In the carpet under
below left A-pillar
32
Ground
1
Connected with ground wire
On the left of BCM
module box
33
Ground
1
Connected with ground wire
In the left ceiling
handle
34
Dormer controllerconnector
6
Sunroof controller harness
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст