Chery QQ6 (S21) / S12LHD. Manual — part 228

10.2 Use pliers to remove the fixing clip of gearshift

control cable outer case and then take off the gearshift

control cable.

10.3 Use a 13# sleeve to loosen the adjusting screw of

clutch control cable and then take off the clutch control

cable.

10.4 Use a 13# sleeve to loosen the fixing bolt of clutch

control cable on the transmission case.

10.5 Use a 17# wrench to loosen the bleeding bolt of

transmission case to discharge the gear oil.

10.6 See Service Manual for Chassis for disassembly

of suspension travel portion.

10.7 Use a crow to pry out the half shaft.

11. Disassembly of suspension portion

11.1 Use a 13# sleeve to remove the fixing bolt for rear

engine mount bracket of transmission case.

Torque: 60±5Nm.

11.2 Use a 18# sleeve to loosen the fixing bolt for front

engine mount bracket.

Torque: 80±5 Nm.

11.3 Use a crane to hoist the engine until the iron chain

just bears tensile force.

11.4 Use a 15# sleeve to loosen the fixing bolt for right

engine mount bracket. (at rear of transmission)

Torque: 100±5 Nm.

11.5 Use a 13# sleeve to loosen the three connecting

bolts for right engine mount bracket.

Torque: 65±5Nm.

11.6 Use a 13# sleeve to loosen the three connecting

bolts for left engine mount bracket.

11.7 Pull out oil pipe connector and junctions of relevant

pipelines. Make sure that relevant junction parts have all

detached.

11.8 Hoist the engine up.

12. Separation of transmission case assembly and engine

12.1 Use a 10# sleeve to remove the gearshift control

cable bracket on the transmission case.

12.2 Use a 13# sleeve to loosen the four fixing bolts for

front engine mount bracket.

Torque: 65±5Nm.

12.3 Use a 13# sleeve to remove the connecting bolt of

transmission case and engine, and then make the engine

and the transmission separate.

Torque: 100±10 Nm.

II. Installation Procedure

1. Please follow the order adverse to that for disassembly to install, but care should be taken for

the following matters.

(1) When hoisting, do not install exhaust manifold first, because the longitudinal separation of

engine compartment is not big enough; otherwise, it may affect the assembly.

(2) After installation, please adjust the stroke of clutch pedal. When adjusting, adjust it to a proper

position according to the corresponding requirements, in case of a too big free stroke of clutch, it

may make sound when shifting gear or fail to release; while in case of a too small stroke, wear of

friction plate may be accelerated and travel weakness may occur, if severely, the friction plate may

be burnt out.

Chapter Ten Disassembly of Intake Manifold

I. Disassembly Procedure

1. Use an 8# sleeve to remove the four fixing bolts of

ignition coil and then remove such connections as

ignition cable/injection nozzle harness etc.

2 Use a 10# sleeve to remove the bolt of intake manifold

fixing bracket.