Chery QQ6 (S21) / S12LHD. Manual — part 229
3. Use a 10# sleeve to remove the fixing bolt of
compressor bracket.
Torque: 30±3 Nm.
4 Use a 10# sleeve to remove the fixing bolt of intake
manifold and then take off the intake manifold assembly.
Torque: 8+3Nm.
Chapter Eleven Disassembly of Cylinder Head
I. Disassembly Procedure
1 Use a 10# sleeve to remove the fixing bolt of valve
cover.
Torque: 8±3 Nm.
2. Get the special tool CH-20010 stuck into the
groove on camshaft.
3. Use a 18# sleeve to loosen the fixing bolt of
camshaft timing gear.
Torque: 120±5Nm.
Note:
There is no difference between intake
camshaft and exhaust camshaft, they can be interchanged.
4. Use a cross-head screwdriver to loosen the fixing
bolt on inner fender of timing gear and then take out
the inner fender of timing gear.
5. Use a 10# sleeve to remove the fixing bolt of
camshaft bearing, take out the camshaft assembly
and then the hydraulic tappet system.
Torque: 9.5±1.5 Nm.
Note:
The positions of both camshaft bearing and
bolts, including the order of camshaft bearing, are
unchangeable, and should be conformity with the marks
during assembly/disassembly.
6. Use an hexagon torque wrench to loosen the
fixing bolt of cylinder head and then take off the
cylinder head assembly.
Torque: 50±5 Nm.
Note:
Follow the order as shown in the figure to
loosen the fixing bolts of cylinder head.
7. Disassembly of valve
7.1 Use a special tool to press down the valve
spring, take out the locking plate, and then take off
valve spring, valve and valve seat insert.
7.2 Use a special tool to pull out the valve oil seal.
II. Overhaul of Cylinder Head System
1. Detection of camshaft
1.1 Measurement of height of cam. Use an outside
micrometer to measure wheel height of the cam.
Wheel height of the intake camshaft: 37.11mm.
Wheel height of the exhaust camshaft: 37.09mm.
1.2 Inspection of camshaft journal. Use an outside
micrometer to measure each journal of the camshaft,
please see Specification Table for specific data.
2. Detection of valve
2.1 Detection of valve spring. Two items of data of
valve spring should be measured.
Length of the spring: 49mm
Squareness of the spring: 1.2mm (limit)
2.2. Detection of valve.
2.2.1 Measurement of diameter of valve stem
Measurement point
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст