Chery A15. Manual — part 167
Chery A15 Maintenance Manual
Chapter Eight: Central Door Lock
Section One: Introduction to Central Door Lock System
Chery A15 adopts full electric-control central door lock system, which is composed of
a four-wire control module, three secondary door lock operating motors, one trunk lid
operating motor, etc. All these locks are activated and inactivated by central door lock
interlocking mechanism controlled by door lock switch at driver’s side. Central door
lock module is located in front left door.
Circuit diagram of central door lock system:
中央门锁控制器
Central door lock controller
棕
Brown
右前门锁执行电机
Front right door lock operating motor
蓝
Blue
左后门锁执行电机
Rear left door lock operating motor
黑
Black
行李箱锁执行电机
Trunk lid lock operating motor
红
Red
油箱盖锁执行电机
Fuel tank cover lock operating motor
绿
Green
右后门锁执行电机
Rear right door lock operating motor
Chery A15 Maintenance Manual
Section Two: Working Principle of Central Door Lock
Pin 4 in central module is the power supplied by constant current S18 30A fuse, pin 2
is earthing. Pin 1 and pin 3 are respectively connected to all operating motors. When
door lock switch at driver’s side is turned to OFF position, all doors are locked; when
door lock switch at driver’s side is turned to ON position, all doors are unlocked.
Section Three: Troubleshooting
1. All door locks do not work
Symptoms:
1). When locking with door lock switch at driver’s side, all locks are not activated.
2). When unlocking with door lock switch at driver’s side, all locks are not activated.
Possible Causes:
1). Constant power supply S18 30A fuse on terminal 30 burned;
2). Circuit fault with central door lock module and S18 30A fuse;
3). Poor earthing;
4). Central door lock module fault.
Action:
First check constant power supply S18 30A fuse of terminal 30 to see if it supplies
12V power, if no power supply and the fuse is normal then check circuit for problem.
If a 12V power is supplied, check the connection between fuse S18 A30 and pin 4 of
central door lock module to see if a 12V power is supplied. If no power supply check
circuit for problem, and if a 12V power is supplied, check pin 2 of central door lock
module to see if it is earthed. If no earthing check circuit for problem, and if it is
earthed, central door lock module is at fault and shall be replaced.
2. Unlocking disabled with all central door locks
Symptom:
Chery A15 Maintenance Manual
1) Unlocking is disabled with all central door locks after being locked.
Possible Cause:
1) Central door lock module fault.
Action:
Replace central door lock module.
3. Locking disabled with all central door locks
Symptom:
Locking is disabled with all central door lock after being unlocked.
Possible Cause:
Central door lock module fault.
Action:
Replace central door lock module.
4. Ohmic values of central door lock motors
Master central door lock motor (at driver’s side): 315Ω;
Door lock motors on doors: 20Ω;
Trunk lid lock motor: 10Ω.
In case of ohmic value exceeding limit or infinite ∞Ω, replace central door lock
resistor.
Chery A15 Maintenance Manual
Chapter Nine: Instruction on Pins of Electrical Units
Section One: Diagram of Engine Front Compartment
Wire Harness Assembly
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст