Chery A15. Manual — part 219
Chery A15 Maintenance Manual
4. Speed Sensors
Possible Cause
4. Fault Code 00283, 00285, 00290, 00287
[Description]
This code will be displayed when open circuit or short
circuit of sensor is detected.
[Tip]
The fault may be caused by poor contact of sensor, short
circuit of sensor coil or wire harness, or problem with
sensor signal processing circuit in ABS ECU.
·
Large or medium open circuit of
sensor adapter
·
Short circuit of sensor circuit
·
Short circuit of sensor plug or wire
harness with earthproof or power
·
ABS ECU sensor signal
processing circuit fault
Check each wheel sensor
Normal
Abnormal
Abnormal
Normal
Yes
Check wire harness between
sensor and ABS ECU
Normal
Replace ABS ECU
Demount ABS ECU plug
and check the resistance
between following
terminals.
Standard value:1.0-1.3kΩ
Shake sensor wire harness
and adapter when
measuring resistance.
MK20I/E
Front left: 1-2
Front right: 19-20
Rear left: 5-6
Rear right: 22-23
Check corresponding
sensor adapter
Dose the fault reoccur?
Refer to
Incidental Fault
Repair
Instruction
Repair adapter
Chery A15 Maintenance Manual
5. ABS Coding Error
Possible Cause
5. Fault Code 01044
[Description]
This code will be displayed when inconsistency
between software coding of ECU and hardware
connection of ABS wire harness is detected.
·
Wrong connection of plunger
pin in ABS wire harness
·
ABS ECU coding error
No
Recode
Check if software coding of ABS ECU is
correct with fault diagnoser
Correct value: refer to related ABS
electrical wiring diagram
Abnormal
Repair wire harness
Check plunger pin conduction in ABS wire
harness
Plunger pin connecter: refer to related ABS
electrical wiring diagram
Chery A15 Maintenance Manual
6. Power Terminal 30
Possible Cause
6. Fault Code 00668
[Description]
This code will be displayed when power terminal 30
supplies power or overvoltage is detected.
·
ABS system fuse burned
·
Battery overvoltage or undervoltage
·
ABS wire harness adapter damage
·
ABS ECU damage
Abnormal
Check ABS system 30 fuse Replace fuse
Normal
Abnormal Abnormal
Check ABS wire harness Repair adapter
adapter
Normal
Recheck. Dose abnormity reoccur? No Refer to Incidental
Fault Repair Instruction
Yes
Check battery voltage
Normal
Measure voltage between
following terminals with ABS
wire harness disconnected to
ECU and ignition switch being
“ON”.
Terminal 8 and 9: 9.5-16.5V
Terminal 24 and 25: 9.5-16.5V
MK20I/E:
Terminal 8 and 4: 9.5-16.5V
Replace ABS ECU
Chery A15 Maintenance Manual
7. ABS Malfunction
Possible Cause
7 Fault Code 01130
[Description]
This code will be displayed when ABS is interfered by
high frequency electromagnetic wave or microprocessor
takes speed signal input as unreliable
·
Interference of high frequency
electromagnetic wave
·
Sensor or sensor wire harness
damage
·
ABS ECU damage
Abnormal Abnormal
Check sensor output voltage Check sensor Replace sensor
Normal Normal
Replace ABS ECU Check wire harness
between ECU and sensor
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст