Chery A11. Manual — part 52
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
2、Remove piston 2
Press down spring with screwdriver, remove locking piece,
spring and piston 2.
After removing, components are as shown in figure. There
are only two pistons.
Loosen connecting bolts on the governor hub sleeve, and
remove the centrifugal block.
Remove snap ring and the rubber sealing ring.
-55-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Revolve two planetary gears to appropriate
position, and then take them out.
For new type structure, remove two differential
side shafts, and then take out two side gears.
For convenience of inspecting scratch on side
gears, move the two side gears to the middle
position.
Remove taper rolling bearing inner race with
special tool 5 X 46 000 297. As shown on figure.
-56-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Remove hex bolts in the speed meter drive
gear case .
Tool: 13# sleeve
Loosen mounting bolts in the speedometer
sensing rotor and carrier.
Take out the speedometer sensing rotor and
carrier, and then remove the sealing ring with
appropriate tool.
-57-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Drift housing sealing ring using appropriate drift.
The bearing outer race may be removed with the
sleeve.
Remove the differential taper rolling bearing
outer race in same method.
2.10、Removing transmission housing
and parking system
Remove the throttle cable with a screwdriver as
shown on figure.
-58-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст