Chery A11. Manual — part 41
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
1.3.3、Clutch A clearance (snap ring
thickness) adjustment
Install 2.2mm thickness snap ring.
Use measuring unit with dial indicator.
Put the indicator right on, pointer must be at zero
position.
Lift up clutch, read the readings. Clearance
should be within 1.80mm ~ 2mm.
If the measured value is too small or big, select a
thinner or thicker snap ring.
-11-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
1.3.4、Central seat clearance (washer
thickness)
Install adjusting washer (2.0mm thickness) and
flanged thrust washer.
Install clutch, brake, oil pump and other middle
units. And retain with bolts. Tighten torque is
10Nm.
While installing, turning it to install into place.
Install adjuster on input shaft and retain it with
bolts.
-12-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
When measuring, the indicator must be
positively placed and the pointer is set to zero
positon.
As shown on fig., pull up the handle; read out
the measured result. Clearance should be within
0.1mm~0.3mm. The measured results may vary
if different thickness washer is used.
-13-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
1.3.5、Differential Pretension
Install adjustor 5P 95 000 286 and tighten to
7Nm, pressing bearing and outer race.
As shown on fig., turn the housing clockwise,
tighten to 7Nm and repeat the above procedures.
As shown on fig., using depth gauge measuring
distance A from bearing outer race to clutch
housing surface.
.For example
Distance A = 10.2mm
-14-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст