Chery A11. Manual — part 40

The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD

Making marks on bolts and gears as shown on

figure.

Turn screw 12 mm counterclockwise from

marking position.

Using appropriate tool tamp mounting bolt

flange edge to distortion.

-7-

The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD

1.3.3.2、Driven shaft clearence adjustment

Assembling requirements:

Install 1.75 mm thickness gasket and sub rear

output gear, and tighten bolt by hand.

To maintain the clearance, select the thickest

washer in alternative dimensions.

After Applying park gear, tighten sub rear

output

gear locking bolts. Tighten torque is 30Nm.

Release the stop gear and repeat the procedures.

Install measuring instrument 5P 05 001 518 with

dial indicator as shown in fig.

-8-

The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD

Set the indicator to zero.

1.Turn the screw until the needle moves.

2.Turn the gear till needle to zero position.

Loosen transmisson lower mount carrier 5P 95 000

288, then turn counterclockwise screw 3/4 turn.

-9-

The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD

Turn the gear to determine indicator reading.

Reading X

For example, X=0.46mm

Washer thickness S is calculated by following

formula:

S = 1.75mm (Xmm – 0.06mm)

S = Required washer thickness

1.75 = Maximun washer thickness provided in table.

X = Measured reading.

0.06 = Selected clearance (select range is from 0.05 to 0.10)

For example

S = 1.75 (0.46 – 0.06)

S = 1.75 – 0.4

S=1.35mm

Measured readings X=0.46mm

Therefore, 1.35mm washer is needed or other washer to replace 1.75mm washer.

If 1.35mm or other thickness washer is installed, the tighten torque (30Nm) should be made again.

Using appropriate tool, damp locking bolt flange

edge to distortion for locking.

-10-