Chery A11. Manual — part 90

CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual

8. Remove the snap ring on 1

st

gear one-way overrun

clutch’s inner racer;

Separate the clutch drum

from the clutch’s inner racer.

ssembly procedure:

Install the one-way overrun

correctly;

Press down the clutch drum;

Install the snap ring on the

one-way overrun clutch’s inner

racer;

9.

A

1.

clutch drum onto the clutch’s

outer racer so that their tooth

forms are engaged

2.

3.

107

CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual

4. Press the clutch’s outer racer on the one-way overrun clutch drum;

ool of KA-000-232 (bearing remover);

6.

aft

Connect the output shaft with

the gear ring;

Install the snap ring on the output

shaft;

Install the output ring and

one-way overrun clutch into the

housing;

Install

the

assembled

transmission on the vehicle.

D

S

rem

Remove the automatic

5. Install the snap ring and retaining ring with the special t

Press fit the tapered roller

bearing on the output sh

with the special tool of

KA-000-300.

7.

8.

9.

10.

riven shaft and governor

pecial tool: KA-000-232 bearing

over

isassembly procedure:

D

1.

108

CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual

109

transmission assembly from the vehicle;

Remove the driven shaft and governor from the automatic transmission assembly;

Take off the governor’s shield;

4. L

e;

ce

on the

th

ssembly procedure:

Press fit the tapered roller bearing

on the driven shaft;

2.

3.

oosen the connecting bolt on the

governor and take off the

governor’s cas

5. Loosen the fixing bolt for the

ntrifugal block

governor’s drum and take off

e centrifugal block;

A

1.

CHERY AUTOMOBILE CO., LTD Automatic Transmission Fault Diagnosis Manual

2. Install the spring and two

adjusting valve spindles on the

governor’s case. Then fix them

with lock pieces;

Install the centrifugal bock on the

governor’s drum and fix it with a

bolt: tightening torque: 10Nm.

Connect the governor’s case and

the drum with bolts: tightening

torque: 10Nm.

3.

4.

110