Chery A11. Manual — part 62
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Install piston A into cylinder A02 050. Install
diaphragm spring 02 090 with its convex surface
upwards.
Install O-ring 02 096 into piston 02 092, and
lubricate O-ring.
Install piston 02 092.
Install snap ring 02098 with special tool 5 X 46
000 301.
-95-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Assembling the whole clutch E assembly.
Install diaphragm spring 02 142 first, and
then install outer teeth sheet steel 02 120 and
friction plate 02 130 alternately.
Install retainer ring 02 140, and fix with snap
ring 01 150.
NOTE:
Adjust as per procedures in section 1.4.3 page
5/8.
Install two snap rings 02 030 and 02 032 onto
worm rod 02 020, and make the two snap
rings interlocked.
Appling lubricating before install O-ring 02
040 onto the worm rod.
-96-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Install worm assembly, and install snap ring 02 022 with a
snap ring pliers.
NOTE:
The worm must be fixed with the snap ring, otherwise there
may exists axial clearance.
Install the clutch assembly into the
housing, shake clutch A to seat clutch.
NOTE:
The thickness of thrust washers in the
engine input shaft must be adjusted. The
engine input shaft should extend 19 mm
out the worm.
-97-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
3.8、Assembling clutch B and 2nd gear one-way overrun clutch.
After applying lubricant to O-ring, install
O-ring 31 220 into clutch drum B 31 140.
-98-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст