Chery A11. Manual — part 48
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
As shown on figure, apply stop shift, using
appropriate tool, loosen rear sub output gear
mounting bolt.
After removing main rear and sub rear output
gear with appropriate tool, new transmission
rear output gear can be removed by hand.
As shown on figure, remove the high speed
washer and oil guide channel.
-39-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
If necessary, using special tool 5 x 46 000 297
and 2 cotter spanners, remove rolling bearing
inner race in direction shown figure.
Turn over transmission by 180o, remove 2
holding units. Then, remove driven shaft with
governor still remained in housing.
If necessary, remove rolling bearing inner race
on driven shaft using socket 5 x 46 000 232.
-40-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Remove output gear and rear gear ring as an
assembly.
Remove slice gear C (refers to sub gear without
wheel).
Release parking position; remove governor cover
and governor assembly.
-41-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Turn over the transmission by 90
o
, remove
protect plate.
Using removing/installing socket 5 x 46 000
155 remove groove nut.
Remove 1st gear one-way overrunning clutch.
-42-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст