Chery A11. Manual — part 132
Chery SQR7160 series sedan ABS system-fault diagnostic and repairing
7
Code 01130
Possible causes
[Note]When ABS is interrupted by high frequency electromagnetic wave
or micro prcrosser recognized an incrorrect input speed signal, code is set.
● high frequency electromagnetic
wave interference
damaged sensor or sensor harness.
● defective ABS ECU
No
Not normal
Replace sensor
Check sensor
Normal
Check sensor output voltage
Check wiring harness
between ECU and sensor.
Normal
Replace ABS ECU
16
11. FAULT W/O CODE DIAGNOSTIC CHART
1
Ignition On (Engine off), ABS warning light is not on
Possible causes
[Note]
ABS warning light not on maybe caused by open warning light voltage
circuit, burned bulb or damaged warning light control unit.
● blown fuse
● burned ABS warning light blub
● open voltage circuit
●damaged ABS warning light control
unit.
Check ABS warning light fuse at
central electrical box.
OKAY
No okey
Replace fuse.
Check central electrical box fuse socket.
Not okey
OKAY
Replace fuse socket
Remove ABS ECU connector
Ignition: ON position
Is warning light on?
YES
NO
Check if ABS
warning light burned?
YES
NO
Replace
Check if wire connecting ABS
warning light control unit and ECU
short to ground?
YES
Replace electrical harness
Check if there is open circuit in
ABS electrical harness voltage
and ground circuit?
Normal
Not normal
Replace wiring harness
Check ABS warning light voltage
and ground circuit connector.
Not normal
Normal
Repair connector
NO
Go to
INTERMITTENT
FAULT DIAGNOSTIC
Does fault appear again?
YES
Replace ABS warning
light control unit
17
Chery SQR7160 series sedan ABS system-fault diagnostic and repairing
Chery SQR7160 series sedan ABS system-fault diagnostic and repairing
2
Engine, ABS warning light does not go off
Possible causes
[Note]
Possible causes:
defective ABS warning light control unit or open ABS warning light ciucuit.
●defective warning light control unit
●open ABS warning light control unit.
● defective ABS ECU.
Note:
This code only applies to a condition under which there is communication between system and scan tool (ABS voltage
supply is ok) and no code set.
Check if there is open wire between
ECU and ABS warning light control
unit.
YES
Replace wiring harness.
NO
Replace
Not normal
OKAY
Check ABS warning light control unit.
Replace ABS ECU
18
3
Abnormal ABS Opearation
Possible Causes:
[Note]This problem has a close relation with driving and road surface
condition, and it is hard to diagnose. If no code set, perform following check:
●Sensor not correctly installed
●Sensor wiring harness has problem
●damaged sensor
●damaged gear ring
●foreign material on sensor
●damaged wheel bearing
● damaged ABS HCU (hydraulic
unit)
● damaged ABS ECU (electronic
controlled unit)
19
Chery SQR7160 series sedan ABS system-fault diagnostic and repairing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст