Chery A11. Manual — part 133
Chery SQR7160 series sedan ABS system-fault diagnostic and repairing
NO
Sensor installed correctly?
Reinstall sensor.
YES
Check sensor output voltage
Not normal
Check each sensor
Replace
Normal
Normal
Not normal
Repair or replace
Normal
Check ABS ECU socket and
central connector
Not normal
Normal
NO
Go to INTERMITTENT
FAULT DIAGNOSIS
YES
Repair wiring harness
or connector
No normal
Replace ABS ECU
YES
Remove ABS ECU.
Check if resistance between
following terminals is within
1.0~1.3 KOhm?
LF: 1-2
RF: 19-20
LR: 5-6
RR: 22-23
Wiggling sensor wiring harness
and connector while measuring.
Does fault appear again?
Repair connector
Check wheel bearing gap
Replace
Not normal
Check each sensor gear ring
Not normal
Normal
Perform HCU DIAGNOSTIC
using scan tool
Not normal
Replace ABS ECU
20
4
Long Brake Pedal Travel
Possible Causes
[Note]Visually inspect if there is an external leakage or mechanical
problem. Check if there is air in system by bleeding method. Check if
normally closed valve exist a leakage problem using haydraulic unit function
on scan tool.
●brake fluid leakage
●normally closed valve leakage
●there is air in system
●brake rotor heavily worn
●manual brake misadjusted
Visually inspect if fitting leaking.
NOT NORMAL
Tignten fitting to specified torque.
NORMAL
NOT NORMAL
Replace brake rotor.
Check if brake rotor worn?
NORMAL
NOT NORMAL
Replace manual brake adjuster unit.
Check manual brake adjuster unit.
NORMAL
Bleeding check
NORMAL
NOT NORMAL
Repeat bleeding procedures
Check if there is a normally closed valve
leakage using HCU DIAGNOSTIC
FUNCTION on scan tool.
NOT NORMAL Replace HCU
(Hydraulic Controlled Unit)
21
Chery SQR7160 series sedan ABS system-fault diagnostic and repairing
Chery SQR7160 series sedan ABS system-fault diagnostic and repairing
5
Depressing Brake Pedel Need Strong Force
Possible Causes
[Note] Check booster and brake pedal travel using conventional methods.
Normally open valve problem can be checked by hydraulic unit diagnostic
function test on scan tool.
●booster problem
●normally open valve problem
NORMAL
NOT NORMAL
Check normally open valve using HCU
DIAGNOSTIC function on scan tool.
Replace HCU
(Hydraulic controlled unit)
Check booster and pedal travel using conventional brake methods.
22
6
No Diagnostic Code Output (No communication with scan tool)
Possible Causes
[
[Note]When no communication with scan tool, it may be caused by open
ABS ECU power and diagnostic circuit.
● blown fuse
●broken diagnostic cable and loose
connector
●defective ABS ECU
●scan tool problem
Can scan tool communicate with
MK 20 ABS ECU on other vehicle?
Scan tool problem. Repair it and
check again.
Check ABS voltage supply fuse.
Replace fuse.
Is there information displayed
on scan tool screen?
Remove ABS ECU connector.
Check ABS ECU terminal 13 and
diagnostic socket
(terminal 7 in scan tool).
Check diagnostic socket voltage
and ground wire, diagnostic wire
and connection. Normal?
Repair diagnostic socket
or ABS wiring harness.
NO
YES
NOT OKAY
OKAY
NO
NO
Repair socket
Connector
or wiring harness.
YES
NO
23
Chery SQR7160 series sedan ABS system-fault diagnostic and repairing
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст