Chery SQR 7160 sedan. Manual — part 49
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Tighten sub rear output gear mounting bolt to 10
Nm with torque wrench.
Only after both gears installed correctly can the
parking plunger be removed easily. Turn gear
with an appropriate bolt repeatly (as shown on
fig.).
Install parking plunger, select stop position, then
tighten the bolt. Tighten torque is 20Nm.
Release stop position, turn the gear, and repeat the
above procedures.
-6-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Making marks on bolts and gears as shown on
figure.
Turn screw 12 mm counterclockwise from
marking position.
Using appropriate tool tamp mounting bolt
flange edge to distortion.
-7-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
1.3.3.2、Driven shaft clearence adjustment
Assembling requirements:
Install 1.75 mm thickness gasket and sub rear
output gear, and tighten bolt by hand.
To maintain the clearance, select the thickest
washer in alternative dimensions.
After Applying park gear, tighten sub rear
output
gear locking bolts. Tighten torque is 30Nm.
Release the stop gear and repeat the procedures.
Install measuring instrument 5P 05 001 518 with
dial indicator as shown in fig.
-8-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
Set the indicator to zero.
1.Turn the screw until the needle moves.
2.Turn the gear till needle to zero position.
Loosen transmisson lower mount carrier 5P 95 000
288, then turn counterclockwise screw 3/4 turn.
-9-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст