Chery SQR 7160 sedan. Manual — part 50
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
Turn the gear to determine indicator reading.
Reading X
For example, X=0.46mm
Washer thickness S is calculated by following
formula:
S = 1.75mm (Xmm – 0.06mm)
S = Required washer thickness
1.75 = Maximun washer thickness provided in table.
X = Measured reading.
0.06 = Selected clearance (select range is from 0.05 to 0.10)
For example
S = 1.75 (0.46 – 0.06)
S = 1.75 – 0.4
S=1.35mm
Measured readings X=0.46mm
Therefore, 1.35mm washer is needed or other washer to replace 1.75mm washer.
If 1.35mm or other thickness washer is installed, the tighten torque (30Nm) should be made again.
Using appropriate tool, damp locking bolt flange
edge to distortion for locking.
-10-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
1.3.3、Clutch A clearance (snap ring
thickness) adjustment
Install 2.2mm thickness snap ring.
Use measuring unit with dial indicator.
Put the indicator right on, pointer must be at zero
position.
Lift up clutch, read the readings. Clearance
should be within 1.80mm ~ 2mm.
If the measured value is too small or big, select a
thinner or thicker snap ring.
-11-
The manual of 4HP14 A/T removing and installing CHERY AUTOMOBILE CO., LTD
1.3.4、Central seat clearance (washer
thickness)
Install adjusting washer (2.0mm thickness) and
flanged thrust washer.
Install clutch, brake, oil pump and other middle
units. And retain with bolts. Tighten torque is
10Nm.
While installing, turning it to install into place.
Install adjuster on input shaft and retain it with
bolts.
-12-
The manual of 4HP14 A/T removing & installing CHERY AUTOMOBILE CO., LTD
When measuring, the indicator must be
positively placed and the pointer is set to zero
positon.
As shown on fig., pull up the handle; read out
the measured result. Clearance should be within
0.1mm~0.3mm. The measured results may vary
if different thickness washer is used.
-13-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст